TOYOBO Co., Ltd., Otsu, Shiga 520-0292, Japan.
J Chem Phys. 2010 Nov 7;133(17):174902. doi: 10.1063/1.3502681.
Doi and Edwards (DE) proposed that the relaxation of entangled linear polymers under large deformation occurs in two steps: the fast chain contraction (via the longitudinal Rouse mode of the chain backbone) and the slow orientational relaxation (due to reptation). The DE model assumes these relaxation processes to be independent and decoupled. However, this decoupling is invalid for a generalized convective constraint release (CCR) mechanism that releases the entanglement on every occasion of the contraction of surrounding chains. Indeed, the decoupling does not occur in the sliplink models where the entanglement is represented by the binary interaction (hooking) of chains. Thus, we conducted primitive chain network simulations based on a multichain sliplink model to investigate the chain contraction under step shear. The simulation quantitatively reproduced experimental features of the nonlinear relaxation modulus G(t,γ). Namely, G(t,γ) was cast in the time-strain separable form, G(t,γ)=h(γ)G(t) with h(γ)=damping function and G(t)=linear modulus, but this rigorous separability was valid only at times t comparable to the terminal relaxation time, although a deviation from this form was rather small (within ±10%) at t>τ(R) (longest Rouse relaxation time). A molecular origin of this delicate failure of time-strain separability at t∼τ(R) was examined for the chain contour length, subchain length, and subchain stretch. These quantities were found to relax in three steps, the fast, intermediate, and terminal steps, governed by the local force balance between the subchains, the longitudinal Rouse relaxation, and the reptation, respectively. The contributions of the terminal reptative mode to the chain length relaxation as well as the subchain length/stretch relaxation, not considered in the original DE model, emerged because the sliplinks (entanglement) were removed via the generalized CCR mechanism explained above and the reformation of the sliplinks was slow at around the chain center compared to the more rapidly fluctuating chain end. The number of monomers in the subchain were kept larger at the chain center than at the chain end because of the slow entanglement reformation at the center, thereby reducing the tension of the stretched subchain at the chain center compared to the DE prediction. This reduction of the tension at the chain center prevented completion of the length equilibration of subchains at t∼τ(R) (which contradicts to the DE prediction), and it forces the equilibration to complete through the reptative mode at t≫τ(R). The delicate failure of time-strain separability seen for G(t,γ) at t∼τ(R) reflects this retarded length equilibration.
多伊和爱德华兹(DE)提出,在大变形下纠缠线性聚合物的松弛发生在两个步骤中:快速链收缩(通过链主链的纵向 Rouse 模式)和缓慢的取向松弛(由于蠕动)。DE 模型假设这些松弛过程是独立和去耦的。然而,对于广义的对流约束释放(CCR)机制来说,这种去耦是无效的,该机制在每次收缩周围链时都会释放缠结。事实上,在滑链模型中不存在这种去耦,在滑链模型中,缠结由链的二元相互作用(挂钩)表示。因此,我们基于多链滑链模型进行了原始链网络模拟,以研究阶跃剪切下的链收缩。模拟定量再现了非线性松弛模量 G(t,γ)的实验特征。即,G(t,γ)可以表示为时间-应变可分离的形式,G(t,γ)=h(γ)G(t),其中 h(γ)为阻尼函数,G(t)为线性模量,但这种严格的可分离性仅在与末端松弛时间 t≪τ(R)(最长的 Rouse 松弛时间)可比的时间有效,尽管在 t>τ(R)(最长 Rouse 松弛时间)时,这种形式存在一定的偏差(在±10%以内)。对于链轮廓长度、亚链长度和亚链拉伸,我们检查了这种在 t∼τ(R)时时间-应变可分离性的微妙失效的分子起源。发现这些量的松弛分为三个步骤,即快速、中间和末端步骤,分别由亚链之间的局部力平衡、纵向 Rouse 松弛和蠕动控制。在原始 DE 模型中没有考虑到末端蠕动模式对链长松弛以及亚链长度/拉伸松弛的贡献,这是因为通过上面解释的广义 CCR 机制去除了滑链(缠结),并且滑链的重新形成在链中心附近比在更快速波动的链端慢。由于中心的缠结重新形成较慢,因此亚链中的单体数量在链中心比在链端保持较大,从而降低了链中心拉伸亚链的张力,与 DE 预测相反。这种链中心张力的降低阻止了在 t∼τ(R)(与 DE 预测相反)时亚链长度平衡的完成,并迫使平衡通过在 t≫τ(R)时的蠕动模式完成。在 t∼τ(R)时,G(t,γ)的时间-应变可分离性的微妙失效反映了这种延迟的长度平衡。