Etchepareborde S, Mills J, Busoni V, Brunel L, Balligand M
School of Veterinary Medicine, University of Liège-Department of Clinical Sciences, Liège, Belgium.
Vet Comp Orthop Traumatol. 2011;24(1):27-31. doi: 10.3415/VCOT-10-01-0013. Epub 2010 Nov 19.
To calculate the difference between the desired tibial tuberosity advancement (TTA) along the tibial plateau axis and the advancement truly achieved in that direction when cage size has been determined using the method of Montavon and colleagues. To measure the effect of this difference on the final patellar tendon-tibial plateau angle (PTA) in relation to the ideal 90°.
Trigonometry was used to calculate the theoretical actual advancement of the tibial tuberosity in a direction parallel to the tibial plateau that would be achieved by the placement of a cage at the level of the tibial tuberosity in the osteotomy plane of the tibial crest. The same principle was used to calculate the size of the cage that would have been required to achieve the desired advancement. The effect of the difference between the desired advancement and the actual advancement achieved on the final PTA was calculated.
For a given desired advancement, the greater the tibial plateau angle (TPA), the greater the difference between the desired advancement and the actual advancement achieved. The maximum discrepancy calculated was 5.8 mm for a 12 mm advancement in a case of extreme TPA (59°). When the TPA was less than 31°, the PTA was in the range of 90° to 95°.
A discrepancy does exist between the desired tibial tuberosity advancement and the actual advancement in a direction parallel to the TPA, when the tibial tuberosity is not translated proximally. Although this has an influence on the final PTA, further studies are warranted to evaluate whether this is clinically significant.
当使用蒙塔冯及其同事的方法确定骨笼尺寸时,计算沿胫骨平台轴所需的胫骨结节前移(TTA)与在该方向上实际实现的前移之间的差异。测量该差异对最终髌腱-胫骨平台角(PTA)相对于理想90°的影响。
运用三角学计算在胫骨嵴截骨平面的胫骨结节水平放置骨笼时,在平行于胫骨平台方向上胫骨结节的理论实际前移量。采用相同原理计算实现所需前移量所需的骨笼尺寸。计算所需前移量与实际实现的前移量之间的差异对最终PTA的影响。
对于给定的所需前移量,胫骨平台角(TPA)越大,所需前移量与实际实现的前移量之间的差异越大。在极端TPA(59°)情况下,12毫米前移量的最大计算差异为5.8毫米。当TPA小于31°时,PTA在90°至95°范围内。
当胫骨结节未向近端移位时,在平行于TPA的方向上,所需的胫骨结节前移量与实际前移量之间确实存在差异。尽管这对最终PTA有影响,但仍需进一步研究以评估这在临床上是否具有重要意义。