Department of Orthopedics, University of Massachusetts Medical Center, Worcester, MA 01655, USA.
Injury. 2010 Nov;41 Suppl 2:S85-9. doi: 10.1016/S0020-1383(10)70016-4.
Test the biomechanical properties of femurs that have undergone reaming with the Reamer Irrigator Aspirator (RIA) device with an aim to prove no difference in torsional strength between matched pairs.
Intact femurs were harvested from embalmed cadavers, representing 19 matched pairs. One femur from each pair was randomly selected to undergo reaming using the RIA to 15 mm. The bones were then cut and potted using a uniform jig for testing. Each specimen was tested in torsion and torsional stiffness was calculated for each pair. Samples were loaded until fracture or 11 3 N·m of torque.
Nine of the reamed specimens and 13 of the unreamed samples remained intact until the machine limit of 113 N·m was reached, representing approximately four times the peak torque of 30N·m seen with stair climbing [Garino J, Beredjiklian P. Core Knowledge in Orthopaedics: Adult Reconstruction and Arthroplasty. Chapter 1, page 33. Mosby, 2007]. Mean torsional stiffness for the reamed group was 532.1 N·m/rad (SD = 208.2), and the unreamed was 546.2 N·m/rad (SD=206). Torsional load capacity was calculated for all specimens and compared in groups in which both reamed and unreamed specimens failed. In these five groups, mean load capacity was 80.6 Nm (SD = 9.5) for the reamed group, and 85 Nm (SD = 16.1) for the unreamed group.
17 of our reamed specimens and all of our unreamed specimens withstood normal physiologic load seen with stair climbing. In addition, 16 of 19 reamed specimens remained intact at twice this load. The specimen in the reamed group with the lowest torsional load capacity was eccentrically reamed in the distal anterior cortex highlighting potential complications. Given these findings, reaming the cortex of the femur with the RIA device for the purpose of harvesting bone graft does not appear to dramatically diminish the mechanical properties of the cortex or require postoperative weight bearing restrictions. However, careful attention must be paid to technique as eccentric reaming either proximally or distally may result in catastrophic failure. Careful attention must be paid to the use of irrigating fluid and post operative blood loss, and a thorough discussion of risk factors including postoperative fracture should be covered when obtaining informed consent.
测试使用扩髓冲洗吸引器(RIA)进行扩髓的股骨的生物力学性能,旨在证明匹配对之间的扭转强度无差异。
从防腐尸体中采集完整的股骨,代表 19 对匹配对。每对中的一根股骨随机选择使用 RIA 扩髓至 15mm。然后使用统一的夹具切割和种植骨头进行测试。每个标本都进行扭转测试,并计算每对的扭转刚度。样本加载至机器限制的 113N·m 或骨折。
在达到机器限制的 113N·m 之前,9 个扩髓样本和 13 个未扩髓样本保持完整,大约是楼梯攀爬时 30N·m 峰值扭矩的四倍[Garino J,Beredjiklian P.《骨科核心知识:成人重建和关节置换》。第 1 章,第 33 页。Mosby,2007]。扩髓组的平均扭转刚度为 532.1N·m/rad(SD=208.2),未扩髓组为 546.2N·m/rad(SD=206)。计算了所有样本的扭转承载能力,并在两组中进行了比较,两组中均有扩髓和未扩髓的样本发生了故障。在这五组中,扩髓组的平均承载能力为 80.6Nm(SD=9.5),未扩髓组为 85Nm(SD=16.1)。
我们的 17 个扩髓样本和所有未扩髓样本都能承受楼梯攀爬时的正常生理负荷。此外,19 个扩髓样本中有 16 个在两倍于该负荷的情况下保持完整。在扩髓组中,扭转承载能力最低的样本在前侧皮质的远端偏心扩髓,突出了潜在的并发症。基于这些发现,使用 RIA 设备扩髓股骨皮质以获取骨移植物似乎不会显著降低皮质的机械性能,也不需要术后负重限制。然而,必须注意技术,因为近端或远端的偏心扩髓可能导致灾难性失败。必须密切注意冲洗液和术后失血量的使用,并在获得知情同意时,彻底讨论包括术后骨折在内的危险因素。