The Physical and Theoretical Chemistry Laboratory, University of Oxford, South Parks Road, Oxford OX1 3QZ, United Kingdom.
Biomacromolecules. 2011 Apr 11;12(4):1041-50. doi: 10.1021/bm101369d. Epub 2011 Feb 22.
A surface force balance was used to measure the normal and shear forces between two mica surfaces each bearing an adsorbed layer of porcine gastric mucin ("Orthana" mucin), genetically similar to human MUC6. This mucin is a highly purified, 546 kDa, weakly negative, polyampholytic molecule with a "dumbbell" structure. Both bare (HP) and hydrophobized (HB) mica substrates were used, and forces were measured under 1 and 30 mg/mL mucin solutions, under pure (no-added-salt) water, and under 0.1 M aqueous Na(+) solution. Normal surface forces were monotonically repulsive in all cases, with onset of repulsion occurring at smaller surface separations, D, in the 0.1 M salt solutions (∼ 20 nm, compared with ∼40 nm for no added salt). Repulsion on HP mica was greater on surface compression than decompression, an effect, attributed to bridging and slow-relaxing additional adsorption on compression, not seen on HB mica, a difference attributed to the denser coverage of mucin hydrophobic moieties on the HB surface. Friction forces increased with compression in all cases, showing hysteretic behavior on HP but not on HB mica, commensurate with the hysteresis observed in the normal measurements. Low friction coefficients μ (= ∂F(s)/∂F(n) < 0.05) were seen up to mean pressures
≈ 0.5 to 1.0 MPa, attributed to low interpenetration of the opposed layers together with hydration lubrication effects, with higher μ (up to 0.4) at higher
attributed to interlayer entanglements and to bridging (for the case of HP mica). Shear forces increased only weakly with sliding speed over the range investigated (80-820 nm s(-1)). The lower friction with HB relative to HP mica suggests a selectivity of the HB surface to the hydrophobic moieties of the mucin that in consequence exposes relatively more of the better-lubricating hydrophilic groups. This surface-selectivity effect on lubrication may have a generality extending to other biological macromolecules that contain both hydrophilic and hydrophobic groups.
使用表面力天平测量了两个带有吸附层猪胃粘蛋白(“Orthana”粘蛋白)的云母表面之间的法向力和剪切力,该粘蛋白与人类 MUC6 基因相似。这种粘蛋白是一种高度纯化的、分子量为 546 kDa 的弱负、多两性分子,具有“哑铃”结构。使用了裸露(HP)和疏水化(HB)云母基底,并在 1 和 30 mg/mL 粘蛋白溶液、纯(无加盐)水和 0.1 M 盐水溶液中测量了力。在所有情况下,法向表面力都是单调排斥的,在 0.1 M 盐溶液中(约 20 nm,而无加盐时约 40 nm),排斥的起始表面分离,D,更小。在 HP 云母上的压缩比减压时的排斥力更大,这种效应归因于桥接和缓慢松弛的额外吸附在压缩时,在 HB 云母上则没有看到,这种差异归因于 HB 表面上粘蛋白疏水区的更密集覆盖。在所有情况下,摩擦力都随压缩而增加,在 HP 云母上表现出滞后行为,但在 HB 云母上则没有,与在法向测量中观察到的滞后行为一致。在低至约 0.5 至 1.0 MPa 的平均压力
下,观察到低摩擦系数μ(= ∂F(s)/∂F(n) < 0.05),归因于对向层的低互贯以及水合润滑效应,而在较高的
下,μ 较高(高达 0.4)归因于层间缠结和桥接(对于 HP 云母)。剪切力仅随滑动速度在研究范围内(80-820 nm s(-1)))略有增加。与 HP 云母相比,HB 云母的低摩擦力表明 HB 表面对粘蛋白疏水区具有选择性,从而暴露出相对更多的更好润滑的亲水基团。这种对润滑的表面选择性效应可能具有普遍性,可扩展到其他含有亲水和疏水基团的生物大分子。