School of Chemical Engineering, Universiti Sains Malaysia, Nibong Tebal, 14300 Penang, Malaysia.
J Hazard Mater. 2012 Sep 30;233-234:184-93. doi: 10.1016/j.jhazmat.2012.07.021. Epub 2012 Jul 14.
A new heterogeneous catalyst for sonocatalytic degradation of amaranth dye in water was synthesized by introducing titania into the pores of zeolite (NaY) through ion exchange method while Fe (III) was immobilized on the encapsulated titanium via impregnation method. XRD results could not detect any peaks for titanium oxide or Fe(2)O(3) due to its low loading. The UV-vis analysis proved a blue shift toward shorter wavelength after the loading of Ti into NaY while a red shift was detected after the loading of Fe into the encapsulated titanium. Different reaction variables such as TiO(2) content, amount of Fe, pH values, amount of hydrogen peroxide, catalyst loading and the initial dye concentration were studied to estimate their effect on the decolorization efficiency of amaranth. The maximum decolorization efficiency achieved was 97.5% at a solution pH of 2.5, catalyst dosage of 2 g/L, 20 mmol/100 mL of H(2)O(2) and initial dye concentration of 10 mg/L. The new heterogeneous catalyst Fe/Ti-NaY was a promising catalyst for this reaction and showed minimum Fe leaching at the end of the reaction.
通过离子交换法将二氧化钛引入沸石(NaY)的孔中,同时通过浸渍法将 Fe(III)固定在封装的钛上,合成了用于水中吖啶染料超声催化降解的新型非均相催化剂。由于负载量低,XRD 结果无法检测到任何氧化钛或 Fe(2)O(3)的峰。负载 Ti 进入 NaY 后,UV-vis 分析证明蓝移向更短的波长,而负载 Fe 进入封装的钛后则检测到红移。研究了不同的反应变量,如 TiO(2)含量、Fe 量、pH 值、过氧化氢量、催化剂负载量和初始染料浓度,以估计它们对吖啶染料脱色效率的影响。在溶液 pH 值为 2.5、催化剂用量为 2 g/L、20 mmol/100 mL H(2)O(2)和初始染料浓度为 10 mg/L 的条件下,最大脱色效率达到 97.5%。新型非均相催化剂 Fe/Ti-NaY 是该反应的一种有前途的催化剂,在反应结束时表现出最小的 Fe 浸出。