Qamruddin Irfan, Qayyum Wasif, Haider Syed Mahmood, Siddiqui Seema Wasif, Rehan Faisal
Department of Orthodontics, Baqai Dental College, Karachi.
J Pak Med Assoc. 2012 Sep;62(9):883-7.
To determine the differences in various linear and angular measurements between erupted and impacted lower third molar group on conventional panoramic radiographs.
The quasi-experimental study based on non-probability convenience sampling and done at the National Institute of Oral Diseases, Karachi, comprised 140 patients having full dentition with bilaterally present mandibular third molars varying between ages of 18-30 years. After clinical examination, 280 lower third molars were divided into two groups; Group A had erupted, while Group B comprised impacted mandibular third molars. All radiographs were traced and measured for five variables to compare the two groups. For statistical purpose, SPSS version 10, and t test were used.
Retromolar space measured from Xi (centre of ramus) was 31.60 +/- 3.33 mm in Group A and 27.02 +/- 4.17mm in Group B. Retromolar space measured from anterior edge of ramus (AER) was 16.30 +/- 2.51 mm in Group A and 11.21 +/- 3.69 in Group B. Mesiodistal width was 13.39 +/- 1.44mm in Group A and 13.80 +/- 1.58 in Group B. Retromolar space/width ratio was 1.22 +/- 0.20 for Group A and 0.82 +/- 0.34 for Group B. Mean angulations in Group A was 5.98 +/- 5.9 degrees whereas 34.56 +/- 27.89 degrees in Group B.
The probability of eruption of the lower third molar increases if retromolar space measured from anterior edge of ramus (AER-7) and centre of rumus point (Xi-7) is 13mm and 25mm respectively, provided the space/width ratio is greater than 1 and angulation is also vertical. Mesiodistal width of the tooth has no significant role in impactions.
确定在传统全景片上已萌出和阻生下颌第三磨牙组之间各种线性和角度测量值的差异。
本准实验研究基于非概率便利抽样,在卡拉奇国立口腔疾病研究所进行,纳入了140例全口牙列、双侧均有下颌第三磨牙且年龄在18至30岁之间的患者。经过临床检查,280颗下颌第三磨牙被分为两组;A组为已萌出的牙齿,而B组为阻生下颌第三磨牙。对所有的X线片进行描图并测量五个变量以比较两组。出于统计学目的,使用了SPSS 10版软件和t检验。
从下颌升支中心(Xi)测量的磨牙后间隙,A组为31.60±3.33mm,B组为27.02±4.17mm。从下颌升支前缘(AER)测量的磨牙后间隙,A组为16.30±2.51mm,B组为11.21±3.69mm。近远中宽度,A组为13.39±1.44mm,B组为13.80±1.58mm。磨牙后间隙/宽度比,A组为1.22±0.20,B组为0.82±0.34。A组的平均角度为5.98±5.9度,而B组为34.56±27.89度。
如果从下颌升支前缘(AER-7)和下颌升支中心点(Xi-7)测量的磨牙后间隙分别为13mm和25mm,且间隙/宽度比大于1且角度垂直,则下颌第三磨牙萌出的可能性增加。牙齿的近远中宽度在阻生方面无显著作用。