Empa - Swiss Federal Laboratories for Materials Science and Technology, 9014 St. Gallen, Switzerland.
Water Res. 2013 Aug 1;47(12):3910-20. doi: 10.1016/j.watres.2013.01.057. Epub 2013 Mar 28.
Carbon nanotubes (CNTs) are often processed in suspended form and therefore a release of CNT-suspensions into the aquatic environment is plausible. In this study, the behaviour of two physico-chemically very different CNT types in the presence of varying, environmentally relevant calcium-containing media was investigated, including the long-term colloidal stability and the sedimentary structures of settled CNTs. Calcium induced CNT flocculation, however, the stability of the CNTs in the medium did not monotonously decrease with increasing calcium concentration. At intermediate calcium concentrations (0.5-1.5 mM Ca) pre-dispersed CNTs were stabilized in humic acid medium to similar, temporarily even to higher degree than in the absence of calcium. Between pH 5 and 8 only at the highest pH an influence on CNT stability was observed by either promoting flocculation or stabilisation depending on the CNT type. Humic acid stabilized CNTs much better than fulvic acid. Generally, the colloidal stability of the long, thick CNTs with higher surface oxygen content was less affected by the media composition. An investigation of the settled CNT material using analytical electron microscopy revealed the presence of spheroidal, bundle-like and net like CNT-agglomerate structures. Calcium possibly acted as bridging agent linking CNTs in a network like manner, temporarily increasing the CNT concentrations stabilized in the supernatants due to the low density of these structures. With increasing settling time the CNTs formed a fluffy sediment layer at the bottom of the reaction vessels. Bundle-like CNT agglomerates were also observed within that layer of settled CNTs, possibly caused by calcium neutralizing the surface charges. Furthermore, the CNT suspensions contained spheroidal CNT agglomerates, most likely residues from the original dry powder that were not disaggregated. The analysis of settled CNT material is a novelty and illustrates CNT agglomerate structures possibly accumulating in the sediments of aquatic systems subsequent to CNT emissions.
碳纳米管(CNTs)通常以悬浮状态进行加工,因此 CNT 悬浮液释放到水生环境中是合理的。在这项研究中,研究了两种物理化学性质非常不同的 CNT 类型在不同的、与环境相关的含钙介质中的行为,包括长期胶体稳定性和沉降 CNT 的沉积结构。然而,钙离子诱导 CNT 絮凝,但是,随着钙离子浓度的增加,CNTs 在介质中的稳定性并没有单调下降。在中间钙离子浓度(0.5-1.5mM Ca)下,预分散的 CNT 在腐殖酸介质中稳定,与不存在钙离子时相似,甚至暂时更稳定。在 pH 值为 5 到 8 之间,只有在最高 pH 值下,根据 CNT 类型,要么促进絮凝,要么稳定,对 CNT 稳定性才有影响。腐殖酸稳定 CNT 的能力远强于富里酸。一般来说,具有较高表面氧含量的长而粗的 CNT 的胶体稳定性受介质组成的影响较小。使用分析电子显微镜对沉降的 CNT 材料进行的研究表明,存在球形、束状和网状 CNT 聚集体结构。钙离子可能作为桥联剂,以网络状的方式连接 CNT,由于这些结构的密度较低,暂时增加了在上清液中稳定的 CNT 浓度。随着沉降时间的增加,CNTs 在反应容器的底部形成一层蓬松的沉积物。在沉降的 CNT 层内也观察到束状 CNT 聚集体,可能是由于钙离子中和了表面电荷。此外,CNT 悬浮液中还含有球形 CNT 聚集体,很可能是原始干粉中未分散的残留物质。沉降 CNT 材料的分析是一个新颖的方法,说明了 CNT 聚集体结构可能在 CNT 排放后在水生系统的沉积物中积累。