Department of Chemical and Biomolecular Engineering, College of Energy and Biotechnology, Seoul National University of Science and Technology, 172 Gongreung 2-dong, Nowon-gu, Seoul 139-743, South Korea.
J Membr Biol. 2013 May;246(5):399-405. doi: 10.1007/s00232-013-9551-x. Epub 2013 May 5.
Spherical phospholipid bilayers, vesicles, were prepared by using the layer-by-layer double emulsion technique, which allows individual layers to be formed asymmetrically. Phases of the layers were adjusted by selecting the lipid tail group. The head group composition of the vesicle outer layer varied 0-100 % of phosphatidylcholine (PC) by 10 % under the condition that the diameter of the vesicle was kept constant. On the outer layer of the vesicle, the phospholipase D (PLD) reacted to convert PC to phosphatidic acid. The reaction induced a curvature change of the vesicles, which eventually led them to rupture. Response time from the PLD injection to the rupture was measured against the different compositions of the outer layer at each phase (solid and liquid) using the fluorescence intensity change of pH-sensitive dye encapsulated in the vesicles. From this measurement, the rupture caused by the PLD reaction was analyzed with respect to the phase asymmetry of the layers and the composition of the outer layer. These results were interpreted with the lipid density and stability of the layers. It was observed that the solid phase of the outer layer had a variance in response time according to the phase of the inner layer, whereas the liquid phase did not. Additionally, the response of the solid phase of the outer layer at the liquid phase of the inner layer was faster than at the solid phase of the inner layer as a result of its stability.
采用层层双乳液技术制备了球形磷脂双层膜(囊泡),该技术允许各层不对称形成。通过选择脂质尾部基团来调整层的相态。在保持囊泡直径不变的条件下,囊泡外层的头部基团组成可以在 10%的范围内从 0%到 100%变化,其中磷脂酰胆碱(PC)的变化幅度为 10%。在囊泡的外层,磷脂酶 D(PLD)反应将 PC 转化为磷脂酸。该反应引起囊泡曲率发生变化,最终导致囊泡破裂。使用囊泡内包裹的 pH 敏感染料的荧光强度变化,测量了在每个相态(固态和液态)下,不同外层组成条件下,从 PLD 注射到破裂的反应时间。根据这些测量结果,结合层的相态不对称性和外层的组成,分析了由 PLD 反应引起的破裂。这些结果通过脂质密度和层的稳定性进行解释。结果表明,外层的固态根据内层的相态呈现出不同的响应时间,而液态则没有。此外,由于其稳定性,内层的液态相态的外层固态的响应速度快于内层的固态相态。