IEEE Trans Biomed Eng. 2013 Oct;60(10):2716-24. doi: 10.1109/TBME.2013.2263310. Epub 2013 May 15.
In medical ultrasound imaging, lateral resolution is limited when using a fixed transmit focusing. Various synthetic aperture (SA) techniques, in which two-way dynamic focusing is enabled by utilizing prebeamformed radio-frequency (RF) data have been proposed for improving the spatial resolution. However, SA methods were not extensively evaluated in terms of their clinical performance. In this paper, a phantom and an in vivo evaluation of the SA method with bidirectional pixel-based focusing (BiPBF) is presented in comparison with the conventional beamforming. The performance of the proposed SA-BiPBF was assessed with a blind study and the established breast imaging-reporting and data system (BI-RADS), in addition to measuring contrast-to-noise ratio (CNR) and signal-to-noise ratio (SNR). Prebeamformed RF data were acquired from a tissue mimicking phantom (Model 040, CIRS Inc., Norfolk, VA, USA) and from patients with breast lesions by using a commercial ultrasound scanning system with a linear array transducer equipped with a research package and parallel data acquisition system (SonixTouch, SonixDAQ, and L14-5/38, Ultrasonix Corp., Canada). In phantom and in vivo experiments, a default setting of a breast preset was applied (e.g., the center frequency of 10 MHz and acoustic output of MI = 0.66). In phantom experiment, the SA-BiPBF method showed higher CNR and SNR values compared to the conventional method (3.4 and 23.9 dB versus 3.1 and 15.8 dB, respectively). In addition, the lateral resolution and penetration depth were increased by 95.4% and 40.3%, respectively. Consistent with the phantom experiment, in the in vivo experiment with ten patients, the CNR value for the SA method was 3.3 ± 0.5 compared to 2.8 ± 0.8 for the conventional method. Similarly, the SNR values with the SA-BiPBF and conventional methods were 34.0 ± 3.6 and 27.2 ± 3.4 dB, respectively. From the experiments, it was shown in side-by-side comparisons that the image quality of the SA-BiPBF method was considerably improved in both phantom and in vivo breast images. However, the SA-BiPBF image showed different features compared to the conventional one in the in vivo experiments. These features are resulting from the increased image quality of the SA-BiPBF method but are not always perceived as improvements by the radiologists.
在医学超声成象中,使用固定发射聚焦时,横向分辨率受到限制。各种合成孔径(SA)技术已经被提出,这些技术通过利用预波束形成的射频(RF)数据来实现双向动态聚焦,从而提高空间分辨率。然而,SA 方法在临床性能方面并没有得到广泛的评估。在本文中,我们提出了一种基于双向像素聚焦(BiPBF)的 SA 方法的体模和体内评估,并与传统波束形成进行了比较。使用盲法研究和已建立的乳腺成像报告和数据系统(BI-RADS)评估了所提出的 SA-BiPBF 的性能,此外还测量了对比噪声比(CNR)和信噪比(SNR)。通过使用配备有研究包和并行数据采集系统的商用超声扫描系统,从组织模拟体模(Model 040,CIRS Inc.,弗吉尼亚州诺福克)和患有乳腺病变的患者中采集了预波束形成的 RF 数据,该系统配备了线性阵列换能器。在体模和体内实验中,应用了默认的乳腺预设设置(例如,中心频率为 10 MHz,MI = 0.66)。在体模实验中,与传统方法相比,SA-BiPBF 方法显示出更高的 CNR 和 SNR 值(分别为 3.4 和 23.9 dB 与 3.1 和 15.8 dB)。此外,横向分辨率和穿透深度分别提高了 95.4%和 40.3%。与体模实验一致,在十位患者的体内实验中,SA 方法的 CNR 值为 3.3 ± 0.5,而传统方法的 CNR 值为 2.8 ± 0.8。同样,SA-BiPBF 和传统方法的 SNR 值分别为 34.0 ± 3.6 和 27.2 ± 3.4 dB。从实验中可以看出,在体模和体内乳腺图像的并排比较中,SA-BiPBF 方法的图像质量得到了显著改善。然而,在体内实验中,SA-BiPBF 图像与传统图像显示出不同的特征。这些特征是由于 SA-BiPBF 方法提高了图像质量所致,但并不总是被放射科医生认为是改进。