Department of Joint Surgery, The First Affiliated Hospital of Sun Yat-Sen University, Guangzhou, Guangdong, China.
J Xray Sci Technol. 2013;21(4):497-506. doi: 10.3233/XST-130400.
To investigate relationship between the tibial mechanical axis and bony landmarks of the calf and foot by developing a new laser-calibrated position for radiography of the lower limb.
A total of 120 volunteers were randomly divided into two groups. All subjects were marked with skin projection of the hypothetical axis of the calf on the frontal and sagittal planes. Radiographs of weight-bearing full-length lower-limb were obtained by the laser-calibrated positioning in the experimental group, and by the use of conventional technique in the control group. To consider the rotation of the calf, radiological features of the knee and ankle were investigated. The relationship between the tibial mechanical axis and the bony landmarks of the calf and foot were also measured.
Anteroposterior view depicted a tangential projection on the superior/inferior tibiofibular syndesmosis and between lateral malleolus and talus in ankle mortise in the experimental group. Bony overlap on the superior/inferior tibiofibular syndesmosis and between lateral malleolus and talus was seen in control group. On the tangential projection, it also presented a clear wheel-like contour of the medial femoral condyle, but a partial overlap between medial femoral condyle and tibial plateau. The femoral joint angle between the connecting line at the lowest point of the medial and lateral femoral condyles and the tibial mechanical axis was 83.6° ± 2.49° in the experimental group and 85.3° ± 2.18° in the control group (P < 0.001). The tibial tubercle-axis distance from the center of the medial and middle one-third of the tibial tubercle to the tibial mechanical axis was 1.5 mm in the experimental group and 3.7 mm in the control group (P < 0.05). The malleoli-axis distance from the midpoint of the bimalleolar line joining the tips of the medial and lateral malleoli to the tibial mechanical axis was 1.9 mm in the experimental group and 6.9 mm in the control group (P < 0.001). Lateral view showed no difference between the tibial mechanical axis and the fibular reference line within two groups.
In the new radiographic position, our data indicate that the hypothetical tibial mechanical axis and fibular reference line, obtained by marking the specified anatomic landmarks of the calf and foot, are located more closely to the tibial mechanical axis by correcting the rotation of the calf and foot during the radiography. On anteroposterior view, the tibial mechanical axis was approximately 2 mm medial to the center of the ankle. This indicates that the hypothetical tibial mechanical axis marked on the skin could be referred to guide the tibial osteotomy in total knee arthroplasty.
通过开发一种新的下肢射线照相激光校准定位,研究胫骨力学轴与小腿和足部骨标志之间的关系。
将 120 名志愿者随机分为两组。所有受试者均在前额和矢状面标记小腿假想轴的皮肤投影。实验组采用激光校准定位,对照组采用常规技术获得负重全长下肢射线照相。为了考虑小腿的旋转,研究了膝关节和踝关节的放射学特征。还测量了胫骨力学轴与小腿和足部骨标志之间的关系。
实验组踝关节矢状面显示胫骨腓骨联合上/下的切线投影和外踝与距骨之间的切线投影。对照组在胫骨腓骨联合上/下和外踝与距骨之间可见骨重叠。在切线投影上,还可以看到内侧股骨髁的清晰轮状轮廓,但内侧股骨髁和胫骨平台之间存在部分重叠。实验组股骨关节角为连接最低点的连线最低点在内外侧股骨髁和胫骨力学轴之间为 83.6°±2.49°,对照组为 85.3°±2.18°(P<0.001)。实验组胫骨结节轴距胫骨结节中心的内中 1/3 到胫骨力学轴为 1.5 毫米,对照组为 3.7 毫米(P<0.05)。实验组内外踝双踝线中点到胫骨力学轴的距离为 1.9 毫米,对照组为 6.9 毫米(P<0.001)。实验组在矢状面胫骨力学轴与腓骨参考线之间无差异。
在新的射线照相位置,我们的数据表明,通过标记小腿和足部的特定解剖标志,获得的假想胫骨力学轴和腓骨参考线在纠正小腿和足部旋转后更接近胫骨力学轴。在前后视图中,胫骨力学轴位于踝关节中心内侧约 2 毫米处。这表明,在全膝关节置换术中,可参考胫骨皮肤上标记的假想胫骨力学轴来指导胫骨截骨。