Department of Mechanical Engineering, Massachusetts Institute of Technology , 77 Massachusetts Avenue, Cambridge, Massachusetts 02139, United States.
ACS Nano. 2013 Dec 23;7(12):11043-54. doi: 10.1021/nn404707j. Epub 2013 Dec 4.
When condensed droplets coalesce on a superhydrophobic nanostructured surface, the resulting droplet can jump due to the conversion of excess surface energy into kinetic energy. This phenomenon has been shown to enhance condensation heat transfer by up to 30% compared to state-of-the-art dropwise condensing surfaces. However, after the droplets jump away from the surface, the existence of the vapor flow toward the condensing surface increases the drag on the jumping droplets, which can lead to complete droplet reversal and return to the surface. This effect limits the possible heat transfer enhancement because larger droplets form upon droplet return to the surface, which impedes heat transfer until they can be either removed by jumping again or finally shedding via gravity. By characterizing individual droplet trajectories during condensation on superhydrophobic nanostructured copper oxide (CuO) surfaces, we show that this vapor flow entrainment dominates droplet motion for droplets smaller than R ≈ 30 μm at moderate heat fluxes (q″ > 2 W/cm(2)). Subsequently, we demonstrate electric-field-enhanced condensation, whereby an externally applied electric field prevents jumping droplet return. This concept leverages our recent insight that these droplets gain a net positive charge due to charge separation of the electric double layer at the hydrophobic coating. As a result, with scalable superhydrophobic CuO surfaces, we experimentally demonstrated a 50% higher overall condensation heat transfer coefficient compared to that on a jumping-droplet surface with no applied field for low supersaturations (<1.12). This work not only shows significant condensation heat transfer enhancement but also offers avenues for improving the performance of self-cleaning and anti-icing surfaces as well as thermal diodes.
当凝聚的液滴在超疏水纳米结构表面上聚结时,由于过剩表面能转化为动能,由此产生的液滴可能会跳跃。与先进的点滴冷凝表面相比,这种现象已被证明可将冷凝传热提高多达 30%。然而,当液滴从表面跳跃离开后,蒸汽流向冷凝表面的存在会增加跳跃液滴的阻力,这可能导致液滴完全反转并返回表面。这种效应限制了可能的传热增强,因为液滴返回表面时会形成更大的液滴,这会阻碍传热,直到它们可以再次跳跃离开,或者最终通过重力脱落。通过在超疏水纳米结构氧化铜 (CuO) 表面上冷凝时对单个液滴轨迹进行特征描述,我们表明,在 moderate 热通量 (q″> 2 W/cm(2)) 下,对于小于 R ≈ 30 μm 的液滴,这种蒸汽流夹带主导了液滴运动。随后,我们展示了电场增强冷凝,其中外施电场可防止跳跃液滴返回。这一概念利用了我们最近的研究成果,即由于疏水性涂层中电双层的电荷分离,这些液滴获得了净正电荷。因此,在具有可扩展的超疏水 CuO 表面的情况下,与无外加电场的跳跃液滴表面相比,在低过饱和度 (<1.12) 下,我们实验证明了 50%更高的总冷凝传热系数。这项工作不仅显示了显著的冷凝传热增强,还为改善自清洁和防冰表面以及热二极管的性能提供了途径。