Nir S, Stutzin A, Pollard H B
Laboratory of Cell Biology and Genetics, NIADDK, Bethesda, MD 20892.
Biochim Biophys Acta. 1987 Oct 2;903(2):309-18. doi: 10.1016/0005-2736(87)90221-5.
Fusion of chromaffin granule ghosts was induced by synexin at pH 6, 37 degrees C, in the presence of 10(-7) M Ca2+. To study the kinetics and extent of this fusion process we employed two assays that monitored continuously mixing of aqueous contents or membrane mixing by fluorescence intensity increases. In both assays chromaffin granule ghosts were either labeled on the membrane or in the included aqueous phase. The ratios of blank to labeled chromaffin granule ghosts were varied from 1 to 10. The results were analyzed in terms of a mass action kinetic model, which views the overall fusion reaction as a sequence of a second-order process of aggregation followed by a first-order fusion reaction. The model calculations gave fare simulations and predictions of the experimental results. The rate constants describing membrane mixing are more than 2-fold larger than those for volume mixing. The analysis also indicated that the initial aggregation and fusion processes, up to dimer formation, were extremely fast. The rate constant of aggregation was close to the limit in diffusion-controlled processes, whereas the fusion rate constant was about the same as found in fastest virus-liposome fusion events at pH 5. A small increase in volume was found to accompany the fusion between chromaffin granule ghosts. Using ratios of synexin to chromaffin granule ghost protein of 0.13, 0.41 and 1.15 indicated that the overall fusion rate was larger for the intermediate (0.41) case. The analysis showed that the main activity of synexin was an enhancement of the rate of aggregation. At intermediate or excessive synexin concentrations it, respectively, promoted moderately, or inhibited the actual fusion step.
在pH 6、37摄氏度、存在10⁻⁷M Ca²⁺的条件下,连丝蛋白可诱导嗜铬粒蛋白颗粒空泡发生融合。为了研究这一融合过程的动力学和程度,我们采用了两种检测方法,通过荧光强度增加来连续监测水相内容物的混合或膜的混合情况。在这两种检测方法中,嗜铬粒蛋白颗粒空泡要么在膜上标记,要么在包含的水相中标记。空白与标记的嗜铬粒蛋白颗粒空泡的比例在1到10之间变化。结果根据质量作用动力学模型进行分析,该模型将整个融合反应视为一个二阶聚集过程,随后是一阶融合反应的序列。模型计算对实验结果进行了合理的模拟和预测。描述膜混合的速率常数比体积混合的速率常数大2倍以上。分析还表明,直至二聚体形成的初始聚集和融合过程极其迅速。聚集的速率常数接近扩散控制过程的极限,而融合速率常数与在pH 5时最快的病毒-脂质体融合事件中发现的速率常数大致相同。发现嗜铬粒蛋白颗粒空泡之间的融合伴随着体积的小幅增加。使用连丝蛋白与嗜铬粒蛋白颗粒空泡蛋白的比例为0.13、0.41和1.15表明,中间比例(0.41)情况下的总体融合速率更大。分析表明,连丝蛋白的主要活性是提高聚集速率。在中间或过量的连丝蛋白浓度下,它分别适度促进或抑制实际的融合步骤。