Department of Oral and Maxillofacial Surgery, Chang Gung Memorial Hospital at Taipei, Chang Gung University College of Medicine, Taoyuan, Taiwan.
Biomed J. 2015 Jan-Feb;38(1):52-7. doi: 10.4103/2319-4170.128722.
This study was designed to analyze the post-rehabilitation occlusal function of subjects treated with complex mandibular resection and subsequently rehabilitated with fibula osteoseptocutaneous flaps, dental implants, and fixed prostheses utilizing the T-scan system.
Ten mandibular complex resection cases that adopted fibula osteoseptocutaneous flaps, dental implants, and fixed prostheses to reconstruct occlusal function were analyzed. The mandibular reconstructions were divided into three groups based on size: full mandibular reconstructions, mandibular reconstructions larger than half of the arch, and mandibular reconstructions smaller than half of the arch. The T-scan III system was used to measure maximum occlusal force, occlusal time, anterior-posterior as well as left-right occlusal force asymmetries, and anterior-posterior as well as left-right asymmetrical locations of occlusal centers.
Subjects with larger mandibular reconstructions and dental implants with fixed partial dentures demonstrated decreased average occlusal force; however, the difference did not reach the statistically significant level (p > 0.05). The most significant asymmetry of occlusal center location occurred among subjects with mandibular reconstructed areas larger than half of the mandibular arch.
Comparison of the parameters of T-scan system used to analyze the occlusal function showed that the occlusal force was not an objective reference. Measurements of the location of the occlusal center appeared more repeatable, and were less affected by additional factors. The research results of this study showed that the size of a reconstruction did not affect the occlusal force after reconstruction and larger reconstructed areas did not decrease the average occlusal force. The most significant parameter was left and right asymmetry of the occlusion center (LROC) and was measured in subjects with reconstruction areas larger than half of the arch.
本研究旨在通过 T-scan 系统分析接受复杂下颌骨切除并随后通过腓骨骨皮瓣、牙种植体和固定义齿进行修复的患者的术后咬合功能。
分析了 10 例采用腓骨骨皮瓣、牙种植体和固定义齿重建咬合功能的下颌骨复杂切除病例。根据大小将下颌骨重建分为三组:全下颌骨重建、重建面积大于半弓和重建面积小于半弓。使用 T-scan III 系统测量最大咬合力、咬合时间、前-后及左-右侧向咬合力不对称和前-后及左-右侧向咬合中心不对称位置。
具有较大下颌骨重建和固定局部义齿的牙种植体的受试者平均咬合力降低,但差异未达到统计学显著水平(p>0.05)。咬合中心位置最显著的不对称发生在重建面积大于半弓的下颌骨的受试者中。
使用 T-scan 系统分析咬合功能的参数比较表明,咬合力不是客观参考。咬合中心位置的测量似乎更具可重复性,并且受其他因素的影响较小。本研究的研究结果表明,重建的大小不会影响重建后的咬合力,较大的重建区域不会降低平均咬合力。最显著的参数是咬合中心的左右不对称(LROC),并在重建面积大于半弓的受试者中进行了测量。