Smith James O, Yasen Sam, Risebury Mike J, Wilson Adrian J
Department of Orthopaedics, Hampshire Hospitals NHS Foundation Trust, Aldermaston Road, Basingstoke, Hampshire, RG24 9NA, United Kingdom.
J Orthop Surg (Hong Kong). 2014 Dec;22(3):318-24. doi: 10.1177/230949901402200310.
To assess distance changes between the femoral and tibial attachment points of 3 different anterior cruciate ligament (ACL) tunnel entry positions throughout the range of knee motion in cadaveric knees.
The ACLs of 11 fresh-frozen cadaveric knees (from 6 men and 5 women) were removed using radiofrequency. Three tibial tunnel placements were made using a cannulated awl, and three 2.4-mm pilot tunnels were drilled on the lateral femoral condyle. One end of an inelastic suture was inserted from each of the 3 femoral holes and fixed on the femoral cortex using a suture button in turn, whereas the other end of the suture was passed through the cannulated awl and fixed on each of the 3 tibial placements in turn, with constant tension. Distance changes of the suture throughout the range of knee movement (0º, 90º, and 135º of knee flexion) were measured for each combination of tibial and femoral positions.
The distance was minimum when the knee was in full extension (p < 0.0001). Most of the distance changes occurred during initial flexion (0º-90º). The most isometric position (mean ± standard deviation [SD] distance change, 2.78 ± 0.93 mm; p < 0.0001) was noted when the suture was at the anteromedial bundle placement in the femur and anterior in the tibia. The least isometric position (mean ± SD distance change, 10.37 ± 2.08 mm; p < 0.0001) was noted when the suture was at the mid-bundle position in the femur and at the posterolateral bundle insertion in the tibia. The anatomic position resulted in a mean ± SD distance change of 7.63 ± 2.01 mm (p < 0.0001). The femoral position had a greater influence on distance change than the tibial position.
None of the ACL graft positions was isometric. Anatomic ACL positioning resulted in comparable anisometry to the native ACL. The minimum distance for all graft positions was noted in full extension, in which position the graft should be fixed during anatomic ACL reconstruction.
评估在尸体膝关节的整个运动范围内,3种不同前交叉韧带(ACL)隧道入口位置的股骨和胫骨附着点之间的距离变化。
使用射频切除11个新鲜冷冻尸体膝关节(6名男性和5名女性)的ACL。使用空心锥子进行3种胫骨隧道放置,并在股骨外侧髁上钻出3个2.4毫米的导针隧道。将一根无弹性缝线的一端从3个股骨孔中的每一个插入,依次使用缝线纽扣固定在股骨皮质上,而缝线的另一端穿过空心锥子并依次固定在3个胫骨放置位置上,保持恒定张力。针对每种胫骨和股骨位置组合,测量缝线在膝关节运动范围(膝关节屈曲0°、90°和135°)内的距离变化。
膝关节完全伸展时距离最小(p < 0.0001)。大部分距离变化发生在初始屈曲阶段(0°-90°)。当缝线位于股骨的前内侧束位置和胫骨的前方时,观察到最等长的位置(平均±标准差[SD]距离变化,2.78±0.93毫米;p < 0.0001)。当缝线位于股骨的中间束位置和胫骨的后外侧束插入点时,观察到最不等长的位置(平均±SD距离变化,10.37±2.08毫米;p < 0.0001)。解剖位置导致平均±SD距离变化为7.63±2.01毫米(p < 0.0001)。股骨位置对距离变化的影响大于胫骨位置。
没有一个ACL移植物位置是等长的。解剖学ACL定位导致与天然ACL相当的各向异性。所有移植物位置在完全伸展时距离最小,在解剖学ACL重建过程中应在此位置固定移植物。