School of Chemical Engineering and Analytical Science, The University of Manchester, Oxford Road, Manchester M13 9PL, UK.
School of Chemical Engineering and Analytical Science, The University of Manchester, Oxford Road, Manchester M13 9PL, UK.
J Hazard Mater. 2015 May 30;289:1-8. doi: 10.1016/j.jhazmat.2015.02.032. Epub 2015 Feb 12.
In this paper, the sorptive kinetic and diffusional characteristics of caesium ion removal from aqueous solution by carbon-supported clinoptilolite composites are presented. Natural clinoptilolite was supported on carbonaceous scaffolds prepared from date stones. Thermal treatment was applied to produce voids in the carbon which was conditioned using polydiallyldimethylammonium chloride to facilitate the clinoptilolite attachment. This method allowed the formation of a consistent zeolite layer on the carbon surface. The composite was applied in the removal of non-radioactive caesium ions showing an enhanced uptake from 55 mg g(-1) to 120.9 mg g(-1) when compared to clinoptilolite. Kinetic studies using Pseudo First Order model revealed an enhanced rate constant for carbon-clinoptilolite (0.0252 min(-1)) in comparison with clinoptilolite (0.0189 min(-1)). The Pseudo-First Order model described the process for carbon-clinoptilolite, meanwhile Pseudo Second Order model adjusted better for pure clinoptilolite. Diffusivity results suggested that mass transfer resistances involved in the Cs(+) sorption are film and intraparticle diffusion for natural clinoptilolite and intraparticle diffusion as the mechanism that controls the process for carbon-clinoptilolite composite. The most significant aspect being that the vitrified volume waste can be reduced by over 60% for encapsulation of the same quantity of caesium due to the enhanced uptake of zeolite.
本文介绍了从水溶液中去除铯离子的碳负载斜发沸石复合材料的吸附动力学和扩散特性。天然斜发沸石负载在由椰枣制备的碳质支架上。热处理应用于产生碳中的空隙,并用聚二烯丙基二甲基氯化铵对其进行调节,以促进斜发沸石的附着。这种方法允许在碳表面形成一致的沸石层。该复合材料应用于去除非放射性铯离子,与斜发沸石相比,其吸附量从 55mg g(-1)提高到 120.9mg g(-1)。使用拟一级动力学模型的动力学研究表明,与斜发沸石相比,碳-斜发沸石的速率常数更高(0.0252 min(-1))。拟一级动力学模型描述了碳-斜发沸石的过程,而拟二级动力学模型更适合纯斜发沸石。扩散性结果表明,对于天然斜发沸石,Cs(+)吸附过程中的传质阻力涉及膜和颗粒内扩散,而对于碳-斜发沸石复合材料,控制过程的机制是颗粒内扩散。由于沸石的吸附量增加,可将相同数量铯的玻璃化体积废物减少 60%以上,这是最重要的方面。