Hellrup Joel, Alderborn Göran, Mahlin Denny
Department of Pharmacy, Uppsala University, Uppsala, Sweden.
Department of Pharmacy, Uppsala University, Uppsala, Sweden.
J Pharm Sci. 2015 Nov;104(11):3760-3769. doi: 10.1002/jps.24583. Epub 2015 Jul 16.
This study aims at investigating the recrystallization of amorphous lactose in nanocomposites. In particular, the focus is on the influence of the nano- to micrometer length scale nanofiller arrangement on the amorphous to crystalline transition. Further, the relative significance of formulation composition and manufacturing process parameters for the properties of the nanocomposite was investigated. Nanocomposites of amorphous lactose and fumed silica were produced by co-spray-drying. Solid-state transformation of the lactose was studied at 43%, 84%, and 94% relative humidity using X-ray powder diffraction and microcalorimetry. Design of experiments was used to analyze spray-drying process parameters and nanocomposite composition as factors influencing the time to 50% recrystallization. The spray-drying process parameters showed no significant influence. However, the recrystallization of the lactose in the nanocomposites was affected by the composition (fraction silica). The recrystallization rate constant decreased as a function of silica content. The lowered recrystallization rate of the lactose in the nanocomposites could be explained by three mechanisms: (1) separation of the amorphous lactose into discrete compartments on a micrometer length scale (compartmentalization), (2) lowered molecular mobility caused by molecular interactions between the lactose molecules and the surface of the silica (rigidification), and/or (3) intraparticle confinement of the amorphous lactose.
本研究旨在探究纳米复合材料中无定形乳糖的重结晶情况。具体而言,重点在于纳米至微米长度尺度的纳米填料排列对无定形向结晶转变的影响。此外,还研究了配方组成和制造工艺参数对纳米复合材料性能的相对重要性。通过共喷雾干燥制备了无定形乳糖和气相二氧化硅的纳米复合材料。使用X射线粉末衍射和微量量热法研究了乳糖在43%、84%和94%相对湿度下的固态转变。采用实验设计来分析喷雾干燥工艺参数和纳米复合材料组成作为影响50%重结晶时间的因素。喷雾干燥工艺参数未显示出显著影响。然而,纳米复合材料中乳糖的重结晶受到组成(二氧化硅分数)的影响。重结晶速率常数随二氧化硅含量的增加而降低。纳米复合材料中乳糖重结晶速率降低可由三种机制解释:(1)无定形乳糖在微米长度尺度上分离成离散隔室(隔室化),(2)乳糖分子与二氧化硅表面之间的分子相互作用导致分子流动性降低(硬化),和/或(3)无定形乳糖在颗粒内的受限。