Nguyen Hau Thi, Chang Wen-Shing, Nguyen Nguyen Cong, Chen Shiao-Shing, Chang Hau-Ming
Institute of Environmental Engineering and Management, National Taipei University of Technology, No. 1, Sec. 3, Chung-Hsiao E. Rd. Taipei 106, Taiwan, ROC E-mail:
Water Sci Technol. 2015;72(11):2045-51. doi: 10.2166/wst.2015.370.
An investigation of micelle properties on the recovery of chromium for micellar enhanced ultrafiltration (MEUF) process was conducted using cationic surfactant of cetyltrimethylammonium bromide (CTAB). The relationship between degree of ionization, micellar sizes and chromium removal were determined in this study. The results showed that the complete ionization for CTA+ and Br- was observed for CTAB lower than 0.72 mM and aggregation initiated at concentration of CTAB higher than 0.72 mM to yield attraction of counterion. The micellar sizes increased with increase in concentration of CTAB (higher than 4.02 mM) to generate micron-sized micelles. The distribution of micellar sizes was used to estimate the molecular weight cutoff of membrane used in the MEUF process. As chromium was added into aqueous CTAB solution, the chromate was dominant and bound on the micellar surface instead of Br-. Moreover, the presence of micelle formed a gel-layer to slightly shrink the membrane pore, therefore, UF membrane of 30k Da molecular weight cutoff (pore size≈7.9 nm) was selected in the MEUF process to achieve the removal efficiency of Cr(VI) higher than 95%.
使用十六烷基三甲基溴化铵(CTAB)阳离子表面活性剂对胶束增强超滤(MEUF)过程中铬回收的胶束性质进行了研究。本研究确定了电离度、胶束尺寸与铬去除之间的关系。结果表明,当CTAB浓度低于0.72 mM时,CTA⁺和Br⁻完全电离,而当CTAB浓度高于0.72 mM时开始聚集,产生反离子吸引。随着CTAB浓度增加(高于4.02 mM),胶束尺寸增大,形成微米级胶束。胶束尺寸分布用于估计MEUF过程中使用的膜的截留分子量。当向CTAB水溶液中添加铬时,铬酸盐占主导并结合在胶束表面而非Br⁻上。此外,胶束的存在形成了凝胶层,使膜孔略有收缩,因此,在MEUF过程中选择截留分子量为30 kDa(孔径≈7.9 nm)的超滤膜,以实现Cr(VI)去除效率高于95%。