Effect of Enamel Preparation and Light Curing Methods on Microleakage under Orthodontic Brackets.

OBJECTIVES

This study aimed to compare the microleakage beneath metallic brackets following two different methods of enamel preparation and light curing.

MATERIALS AND METHODS

A total of 120 bovine deciduous lower incisors were randomly divided into four groups of 30 teeth. The preparations were as follows: Group I: Acid etching + Transbond XT primer + direct illumination, group II: acid etching + Transbond XT primer + transillumination, group III: Transbond XT self-etching primer + direct illumination and Group IV: Transbond XT self-etching primer + transillumination. Dye penetration was used as the method of microleakage evaluation. Sections made at the enamel-adhesive and adhesive-bracket interfaces were evaluated under a stereomicroscope. The Kruskal-Wallis and Mann-Whitney U tests were used for statistical analysis. The level of significance was set at P<0.05.

RESULTS

All groups showed greater microleakage at the gingival in comparison to the incisal margin and the differences were significant among groups with transillumination (P<0.001). No significant differences were observed in the microleakage scores at the gingival and incisal margins in any of the interfaces (P>0.05). Mesiodistal margins of the self-etching group with direct illumination showed significantly lower scores in comparison with acid etched group (P<0.05).

CONCLUSION

Use of self-etching primers for bonding of orthodontic brackets yields acceptable results if all bracket margins are cured directly.