Cooper Justin T, Harris Joel M
Department of Chemistry, University of Utah, Salt Lake City, Utah, USA.
Department of Chemistry, University of Utah, Salt Lake City, Utah, USA
Appl Spectrosc. 2016 Apr;70(4):695-701. doi: 10.1177/0003702816631312. Epub 2016 Feb 17.
Fluorescence correlation spectroscopy (FCS) has become an important technique for the characterization of molecular dynamics, especially at interfaces. Fluorescence correlation spectroscopy provides both temporal and spatial resolution for measuring fast processes at equilibrium through analysis of noise in fluorescence intensities from the statistical fluctuations in a small number of molecules. The small molecular populations produce very low-level fluorescence signals, where time-averaging the fluorescence autocorrelation function is needed to generate reasonable signal-to-noise (S/N) ratios. Recently imaging cameras have been adapted to FCS measurements of molecular dynamics at interfaces (membranes and surfaces) through the use of electron-multiplying charge-coupled device (EM-CCD) detectors for acquisition of fluorescence from addressable areas on the detector. This approach provides a major advantage over traditional focused-spot FCS by allowing electronic control over the location and area of the acquired region on the sample surface. Imaging-FCS can also provide a spatial multiplexing advantage through its ability to measure intensity data from larger areas in parallel with no loss of time resolution. In this work, this multiplexing advantage is exploited to determine molecular diffusion rates from the simultaneous measurement of multiple areas on a surface, the autocorrelation traces from which are averaged to improve the S/N ratio. As proof of concept, the diffusion of 1,1'-dioctadecyl-3,3,3'3'-tetramethylindocarbocyanine perchlorate (DiI) on a C18-modified interface was measured using this multiplexed method and compared to autocorrelation data acquired from a single spot. Due to the slow thermal recovery of the EM-CCD that inhibits fast time-averaging, spatial multiplexing in imaging-FCS provides an eightyfold time savings to reach the same S/N ratio as multiple (time-averaged) measurements from a single spot.
荧光相关光谱法(FCS)已成为表征分子动力学的一项重要技术,尤其是在界面处。荧光相关光谱法通过分析少量分子统计涨落引起的荧光强度噪声,为测量平衡状态下的快速过程提供了时间和空间分辨率。小分子群体产生的荧光信号非常微弱,需要对荧光自相关函数进行时间平均以产生合理的信噪比(S/N)。最近,成像相机已通过使用电子倍增电荷耦合器件(EM-CCD)探测器来适应界面(膜和表面)分子动力学的FCS测量,以采集探测器上可寻址区域的荧光。这种方法相对于传统的聚焦点FCS具有一个主要优势,即可以通过电子控制来确定样品表面采集区域的位置和面积。成像FCS还可以通过其并行测量更大区域强度数据且不损失时间分辨率的能力提供空间复用优势。在这项工作中,利用这种复用优势从表面多个区域的同时测量中确定分子扩散速率,对这些区域的自相关轨迹进行平均以提高信噪比。作为概念验证,使用这种复用方法测量了1,1'-二辛基-3,3,3'3'-四甲基吲哚碳菁高氯酸盐(DiI)在C18修饰界面上的扩散,并与从单个点采集的自相关数据进行了比较。由于EM-CCD的热恢复缓慢,抑制了快速时间平均,成像FCS中的空间复用可节省80倍的时间,以达到与从单个点进行多次(时间平均)测量相同的信噪比。