Cardona Isabel, Park Ho Il, Lin Lian-Shin
Department of Civil and Environmental Engineering, West Virginia University, Morgantown, WV 26505, USA.
Water Environ Res. 2016 Mar;88(3):210-6. doi: 10.2175/106143016X14504669767571.
An improved method was used to determine chemical oxygen demand (COD) as a measure of organic content in water samples containing high chloride content. A contour plot of COD percent error in the Cl(-)-Cl(-):COD domain showed that COD errors increased with Cl(-):COD. Substantial errors (>10%) could occur in low Cl(-):COD regions (<300) for samples with low (<10 g/L) and high chloride concentrations (>25 g/L). Applying the method to flowback water samples resulted in COD concentrations ranging in 130 to 1060 mg/L, which were substantially lower than the previously reported values for flowback water samples from Marcellus Shale (228 to 21 900 mg/L). It is likely that overestimations of COD in the previous studies occurred as result of chloride interferences. Pretreatment with mercuric sulfate, and use of a low-strength digestion solution, and the contour plot to correct COD measurements are feasible steps to significantly improve the accuracy of COD measurements.
采用一种改进方法来测定化学需氧量(COD),以此作为高氯含量水样中有机成分的度量。在Cl⁻-Cl⁻:COD域中COD百分比误差的等高线图表明,COD误差随Cl⁻:COD的增加而增大。对于低(<10 g/L)和高氯浓度(>25 g/L)的样品,在低Cl⁻:COD区域(<300)可能会出现较大误差(>10%)。将该方法应用于返排水样品,得到的COD浓度范围为130至1060 mg/L,这大大低于先前报道的来自马塞勒斯页岩的返排水样品的值(228至21900 mg/L)。先前研究中COD的高估很可能是氯化物干扰的结果。用硫酸汞进行预处理、使用低强度消解溶液以及利用等高线图校正COD测量值,是显著提高COD测量准确性的可行步骤。