Kochanski Ryan B, Pal Gian, Bus Sander, Metman Leo Verhagen, Sani Sepehr
Department of Neurosurgery, Rush University Medical Center, 1725 W. Harrison Street, Suite 855, Chicago, IL 60612, United States.
Section on Movement Disorders, Department of Neurology, Rush University Medical Center, 1725 W. Harrison Street, Suite 755, Chicago, IL 60612, United States.
J Clin Neurosci. 2017 Jun;40:130-135. doi: 10.1016/j.jocn.2017.02.037. Epub 2017 Mar 2.
Microelectrode recording (MER) is used to confirm electrophysiological signals within intended anatomic targets during deep brain stimulation (DBS) surgery. We describe a novel technique called intraoperative CT-guided extrapolation (iCTE) to predict the intended microelectrode trajectory and, if necessary, make corrections in real-time before dural opening. Prior to dural opening, a guide tube was inserted through the headstage and rested on dura. Intraoperative CT (iCT) was obtained, and a trajectory was extrapolated along the path of the guide tube to target depth using targeting software. The coordinates were recorded and compared to initial plan coordinates. If needed, adjustments were made using the headstage to correct for error. The guide tube was then inserted and MER ensued. At target, iCT was performed and microelectrode tip coordinates were compared with planned/adjusted track coordinates. Radial error between MER track and planned/adjusted track was calculated. For comparison, MER track error prior to the iCTE technique was assessed retrospectively in patients who underwent MER using iCT, whereby iCT was performed following completion of the first MER track. Forty-seven MER tracks were analyzed prior to iCTE (pre-iCTE), and 90 tracks were performed using the iCTE technique. There was no difference between radial error of pre-iCTE MER track and planned trajectory (2.1±0.12mm) compared to iCTE predicted trajectory and planned trajectory (1.76±0.13mm, p>0.05). iCTE was used to make trajectory adjustments which reduced radial error between the newly corrected and final microelectrode tip coordinates to 0.84±0.08mm (p<0.001). Inter-rater reliability was also tested using a second blinded measurement reviewer which showed no difference between predicted and planned MER track error (p=0.53). iCTE can predict and reduce trajectory error for microelectrode placement compared with the traditional use of iCT post MER.
微电极记录(MER)用于在深部脑刺激(DBS)手术期间确认预定解剖靶点内的电生理信号。我们描述了一种名为术中CT引导外推法(iCTE)的新技术,用于预测预定的微电极轨迹,并在必要时在硬脑膜打开前实时进行校正。在硬脑膜打开之前,将一根导管穿过头端并放置在硬脑膜上。获取术中CT(iCT)图像,并使用靶向软件沿着导管路径将轨迹外推至目标深度。记录坐标并与初始计划坐标进行比较。如有需要,使用头端进行调整以纠正误差。然后插入导管并进行MER。到达靶点后,进行iCT检查,并将微电极尖端坐标与计划/调整后的轨迹坐标进行比较。计算MER轨迹与计划/调整后轨迹之间的径向误差。为了进行比较,对采用iCT进行MER的患者进行回顾性评估,以评估在iCTE技术应用之前MER轨迹的误差,即在完成第一条MER轨迹后进行iCT检查。在iCTE技术应用之前(iCTE前)分析了47条MER轨迹,使用iCTE技术进行了90条轨迹的操作。iCTE前MER轨迹的径向误差与计划轨迹(2.1±0.12mm)相比,与iCTE预测轨迹和计划轨迹(1.76±0.13mm,p>0.05)之间没有差异。iCTE用于进行轨迹调整,将新校正的微电极尖端坐标与最终微电极尖端坐标之间的径向误差降低至0.84±0.08mm(p<0.001)。还使用第二名盲测测量审核员测试了评分者间信度,结果显示预测的和计划的MER轨迹误差之间没有差异(p=0.53)。与传统的在MER后使用iCT相比,iCTE可以预测并减少微电极放置的轨迹误差。