Suppr超能文献

金纳米粒子正电荷单层在二氧化硅传感器上的形成。

Formation of positively charged gold nanoparticle monolayers on silica sensors.

机构信息

Jerzy Haber Institute of Catalysis and Surface Chemistry, Polish Academy of Sciences, Niezapominajek 8, PL-30239 Krakow, Poland.

Institute of Nuclear Physics, Polish Academy of Sciences, Radzikowskiego 152, PL-31342 Krakow, Poland.

出版信息

J Colloid Interface Sci. 2017 Sep 1;501:192-201. doi: 10.1016/j.jcis.2017.04.038. Epub 2017 Apr 13.

Abstract

Formation of positively charged gold nanoparticle monolayers on the Si/SiO was studied under in situ conditions using quartz microbalance (QCM). The gold nanoparticles were synthesized in a chemical reduction method using sodium borohydride as reducing agent. Cysteamine hydrochloride was applied to generate a positive surface charge of nanoparticles. The micrographs obtained from transmission electron microscopy (TEM) revealed that the average size of nanoparticles was equal to 12±3nm. The stability of nanoparticle suspensions under controlled pH and ionic strength was determined by dynamic light scattering (DLS). The electrophoretic mobility measurements showed that the zeta potential of nanoparticles was positive, decreasing with ionic strength and pH from 56mV at pH 4.2 and I=10M to 22mV at pH 8.3 and I=3×10M. The surface enhanced Raman spectroscopy (SERS) confirmed chemisorption of cysteamine on nanoparticles and the contribution of amine moieties in the generation of nanoparticle charge. The influence of suspension concentration, ionic strength and flow rate on the kinetics of nanoparticle deposition on the sensors was quantitatively determined. It was confirmed that the deposition for the low coverage regime is governed by the bulk mass transfer that results in a linear increase of the coverage with time. The significant increase in the maximum coverage of gold monolayers with ionic strength was interpreted as due to the decreasing range of the electrostatic interactions among deposited particles. Moreover, the hydratation of formed monolayers, their structure and the stability were determined by the comparison of the QCM results with those obtained by AFM and SEM. The experimental data were adequately interpreted in terms of the extended random sequential adsorption (eRSA) model that considers the bulk and surface transfer steps in a rigorous way. The obtained results are useful for a facile fabrication of gold nanoparticle-based biosensors capable to bind target molecules via available amine moieties.

摘要

采用石英晶体微天平(QCM)原位研究了带正电荷的金纳米粒子单层在 Si/SiO 上的形成。金纳米粒子是通过使用硼氢化钠作为还原剂的化学还原法合成的。半胱氨酸盐酸盐用于产生纳米粒子的正表面电荷。透射电子显微镜(TEM)获得的显微照片显示,纳米粒子的平均尺寸等于 12±3nm。通过动态光散射(DLS)确定了在控制 pH 和离子强度下纳米粒子悬浮液的稳定性。电泳迁移率测量表明,纳米粒子的 ζ 电位为正,随着离子强度和 pH 值从 4.2 时的 56mV 和 I=10M 降低到 8.3 时的 22mV 和 I=3×10M。表面增强拉曼光谱(SERS)证实了半胱氨酸胺在纳米粒子上的化学吸附以及胺基在纳米粒子电荷产生中的贡献。定量确定了悬浮液浓度、离子强度和流速对纳米粒子在传感器上沉积动力学的影响。证实了对于低覆盖率的沉积由体相质量传递控制,这导致覆盖率随时间线性增加。随着离子强度的增加,金单层的最大覆盖率显著增加,这解释为沉积颗粒之间的静电相互作用范围减小所致。此外,通过将 QCM 结果与 AFM 和 SEM 获得的结果进行比较,确定了形成的单层的水合作用、结构和稳定性。实验数据根据扩展随机顺序吸附(eRSA)模型进行了适当解释,该模型严格考虑了体相和表面传递步骤。获得的结果对于易于制造基于金纳米粒子的生物传感器是有用的,这些生物传感器能够通过可用的胺基结合靶分子。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验