Laboratoire PMMH, UMR 7636 CNRS/ESPCI Paris/PSL Research University/Sorbonne Universités, UPMC Univ Paris 06,/Univ Paris Diderot, 10 rue Vauquelin, 75231 Paris cedex 05, France.
Sorbonne Universités, UPMC Univ Paris 06, CNRS, UMR 7190, Institut Jean Le Rond d'Alembert, F-75005, Paris, France.
Phys Rev E. 2018 Feb;97(2-1):022901. doi: 10.1103/PhysRevE.97.022901.
We study the quasistatic penetration of a flexible beam into a two-dimensional dense granular medium lying on a horizontal plate. Rather than a buckling-like behavior we observe a transition between a regime of crack-like penetration in which the fiber only shows small fluctuations around a stable straight geometry and a bending regime in which the fiber fully bends and advances through series of loading and unloading steps. We show that the shape reconfiguration of the fiber is controlled by a single nondimensional parameter L/L_{c}, which is the ratio of the length of the flexible beam L to L_{c}, a bending elastogranular length scale that depends on the rigidity of the fiber and on the departure from the jamming packing fraction of the granular medium. We show, moreover, that the dynamics of the bending transition in the course of the penetration experiment is gradual and is accompanied by a symmetry breaking of the granular packing fraction in the vicinity of the fiber. Together with the progressive bending of the fiber, a cavity grows downstream of the fiber and the accumulation of grains upstream of the fiber leads to the development of a jammed cluster of grains. We discuss our experimental results in the framework of a simple model of bending-induced compaction and we show that the rate of the bending transition only depends on the control parameter L/L_{c}.
我们研究了柔性梁在二维密集颗粒介质上的准静态穿透。我们观察到的不是类似于屈曲的行为,而是在一个裂缝状穿透的区域和一个弯曲的区域之间的转变,在裂缝状穿透的区域中,纤维只在稳定的直线几何形状周围发生小的波动,而在弯曲的区域中,纤维完全弯曲并通过一系列加载和卸载步骤前进。我们表明,纤维的形状重构由一个单一的无量纲参数 L/L_{c}控制,L/L_{c}是柔性梁的长度 L 与 L_{c}的比值,L_{c}是弯曲弹性颗粒的长度尺度,它取决于纤维的刚性和颗粒介质偏离堆积填充率的程度。此外,我们还表明,在穿透实验过程中弯曲过渡的动力学是逐渐的,并伴随着纤维附近颗粒堆积填充率的对称性破坏。随着纤维的逐渐弯曲,纤维下游会形成一个空腔,而纤维上游的颗粒积累会导致颗粒的堵塞团块的形成。我们在弯曲诱导压实的简单模型框架内讨论了我们的实验结果,并表明弯曲过渡的速率仅取决于控制参数 L/L_{c}。