Department of Biomedical Science and Public Health, School of Medicine, University "Politecnica delle Marche", Ancona, Italy.
Cell Calcium. 2018 Jul;73:95-103. doi: 10.1016/j.ceca.2018.04.007. Epub 2018 Apr 20.
Na/Ca exchangers (NCX) mediate bidirectional Ca fluxes across cell membranes and contribute to Ca homeostasis in many cell types. Exchangers are regulated by gating reactions that depend on Na and Ca binding to transport and regulatory sites. A Na-dependent inactivation is prominent in all isoforms, whereas Ca-dependent regulation varies among isoforms. Here we characterize new details of NCX operation and describe differences and similarities between NCX3 and NCX1 regulation by intracellular Ca and ATP. To compare isoforms, we employed BHK cells expressing NCX3 or NCX1 constitutively and exchange activity was analysed in whole-cell and excised patch recordings under "zero-trans" conditions (i.e., with only one transported ion species on each side). Using BHK cells with low cytoplasmic Ca buffering, outward (reverse) currents, reflecting Ca influx, are activated by applying extracellular Ca (Ca) in the presence of Na on the cytoplasmic side. When firstly activated, peak outward NCX3 currents rapidly decay over seconds and then typically develop a secondary transient peak with slower kinetics, until Ca removal abolishes all outward current. The delayed rise of outward current is the signature of an activating process since peak outward NCX3 currents elicited at subsequent Ca bouts remain stimulated for minutes and slower decline towards a non-zero level during continued Ca application. Secondary transient peaks and current stimulation are suppressed by increasing the intracellular Ca buffer capacity or by replacing cytoplasmic ATP with the analogues AMP-PNP or ATPγS. In BHK cells expressing NCX1, outward currents activated under identical settings decay to a steady-state level during single Ca application and are significantly larger, causing strong and long-lived run down of subsequent outward currents. NCX1 current run down is not prevented by increasing cytoplasmic Ca buffering but secondary transient peaks in the outward current profile can be resolved in the presence of ATP. Finally, inward currents recorded in patches excised from NCX3-expressing cells reveal a proteolysis-sensitive, Ca-dependent inactivation process that is unusual for NCX1 forward activity. Together, our results suggest that NCX function is regulated more richly than appreciated heretofore, possibly including processes that are lost in excised membrane patches.
钠钙交换器(NCX)介导细胞内外钙离子的双向流动,并有助于许多细胞类型的钙稳态。交换器的功能受门控反应的调节,这些反应依赖于钠离子和钙离子与转运和调节部位的结合。所有同工型中都存在明显的钠离子依赖性失活,而钙离子依赖性调节则因同工型而异。在这里,我们描述了 NCX 功能的新细节,并描述了 NCX3 和 NCX1 同工型通过细胞内钙离子和 ATP 的调节之间的差异和相似之处。为了比较同工型,我们使用恒表达 NCX3 或 NCX1 的 BHK 细胞,在“零转运”条件下(即在每一侧只有一种转运离子)进行全细胞和膜片钳记录的交换活性分析。使用细胞质钙离子缓冲能力低的 BHK 细胞,在细胞质侧存在钠离子的情况下,施加细胞外钙离子(Ca)可激活外向(反向)电流,反映钙离子内流。当首次被激活时,峰值外向 NCX3 电流在数秒内迅速衰减,然后通常会出现具有较慢动力学的二次瞬时峰值,直到去除 Ca 消除所有外向电流。外向电流的延迟上升是激活过程的特征,因为在随后的 Ca 冲击中激发的峰值外向 NCX3 电流在数分钟内仍然受到刺激,并且在持续的 Ca 应用过程中,电流下降缓慢至非零水平。随着细胞内 Ca 缓冲能力的增加或用 AMP-PNP 或 ATPγS 等类似物替代细胞质 ATP,二次瞬时峰值和电流刺激会受到抑制。在表达 NCX1 的 BHK 细胞中,在相同条件下激活的外向电流在单次 Ca 应用期间衰减至稳定水平,并且显著增大,导致随后的外向电流强烈且持久的失活。增加细胞质 Ca 缓冲并不能防止 NCX1 电流失活,但在存在 ATP 的情况下,可以解决外向电流曲线中的二次瞬时峰值。最后,从表达 NCX3 的细胞中分离出的膜片钳记录的内向电流揭示了一种蛋白水解敏感的、依赖钙离子的失活过程,这对于 NCX1 的正向活性来说是不寻常的。总之,我们的结果表明,NCX 的功能比以前认为的更为丰富,可能包括在膜片钳记录中丢失的过程。