Suppr超能文献

全膝关节置换术后患者的 DXA 测量股骨远端骨密度:方法学建立和可重复性。

DXA Measured Distal Femur Bone Mineral Density in Patients After Total Knee Arthroplasty: Method Development and Reproducibility.

机构信息

Osteoporosis Clinical Research Program, University of Wisconsin-Madison, Madison, WI, USA;.

Osteoporosis Clinical Research Program, University of Wisconsin-Madison, Madison, WI, USA.

出版信息

J Clin Densitom. 2019 Jan-Mar;22(1):67-73. doi: 10.1016/j.jocd.2018.08.003. Epub 2018 Aug 13.

Abstract

INTRODUCTION

Total knee arthroplasty (TKA) is increasingly being performed. Distal femur periprosthetic fracture is a potentially catastrophic complication following TKA and existing data document substantial distal femur bone mineral density (BMD) loss following TKA. However, distal femur BMD is virtually never measured clinically as no consensus approach exists. This pilot study's purpose was to define regional BMD variation throughout the femur, suggest standard dual-energy X-ray absorptiometry (DXA) regions of interest (ROIs) and evaluate BMD reproducibility at these ROIs.

METHODS

Thirty volunteers 2-5 yr post TKA had both entire femurs imaged twice using a Lunar iDXA with subject repositioning between scans; the atypical femur fracture feature of enCORE software was utilized. To define femoral BMD distribution, custom 1 cm ROIs were stacked one atop the other starting at the intercondylar notch and continuing to the base of the lesser trochanter. Femur length was measured with the ruler tool to calculate distance at 5% increments. ROIs encompassing each 5% increment were utilized to measure BMD at each location. Descriptive statistics were used to determine mean BMD at each ROI and reproducibility at the 15%, 25%, 45%, 60%, and 80% ROIs.

RESULTS

The 5 and 10% ROIs included prosthetic and/or patella, causing high BMD values. Distal femur BMD was lowest at the 15% ROI and was higher (p < 0.05) at each more proximal ROI to 45%, then plateaued from 45% to 75%. BMD reproducibility at these regions was excellent; coefficient of variation (CV) from ∼1% to 3.5%. As periprosthetic fractures generally occur in the distal femur, we propose measuring femur BMD using ROIs placed at 15% and 25%. A 60% region could also be used as a highly cortical site.

CONCLUSION

Existing DXA capabilities allow distal femur BMD measurement with good reproducibility. Further research using standardized ROIs to assess distal femur BMD loss after TKA, and interventions to mitigate this loss, is indicated.

摘要

引言

全膝关节置换术(TKA)的应用日益增多。膝关节置换术后股骨假体周围骨折是一种潜在的灾难性并发症,现有的数据表明,膝关节置换术后股骨远端骨密度(BMD)大量丢失。然而,由于目前还没有统一的方法,临床上几乎没有测量过股骨远端的 BMD。本研究旨在定义股骨的区域性 BMD 变化,提出标准的双能 X 线吸收法(DXA)感兴趣区(ROI),并评估这些 ROI 下的 BMD 可重复性。

方法

30 名膝关节置换术后 2-5 年的志愿者使用 Lunar iDXA 进行了两次整个股骨的成像,两次扫描之间需要重新定位患者;利用 enCORE 软件的非典型股骨骨折特征。为了定义股骨 BMD 分布,从髁间切迹开始,将定制的 1cm ROI 一个叠在另一个上面,一直延伸到小转子的底部。使用标尺工具测量股骨长度,以计算 5%的增量距离。利用 ROI 测量每个位置的 BMD。使用描述性统计来确定每个 ROI 的平均 BMD 和 15%、25%、45%、60%和 80% ROI 的可重复性。

结果

第 5%和 10%的 ROI 包括假体和/或髌骨,导致 BMD 值较高。股骨远端 BMD 在 15% ROI 处最低,在更靠近近端的 ROI 处(45%)更高(p <0.05),然后在 45%到 75%之间达到平台期。这些区域的 BMD 可重复性很好;变异系数(CV)约为 1%至 3.5%。由于假体周围骨折通常发生在股骨远端,我们建议使用放置在 15%和 25%的 ROI 来测量股骨 BMD。也可以使用 60%的 ROI 作为一个高皮质部位。

结论

现有的 DXA 能力允许对股骨远端 BMD 进行测量,具有良好的可重复性。需要进一步使用标准化 ROI 评估膝关节置换术后股骨远端 BMD 丢失,并研究干预措施来减轻这种丢失。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验