Loessner Martin J, Maier Simon K, Schiwek Patrick, Scherer Siegfried
Institut für Mikrobiologie, Forschungszentrum für Milch und Lebensmittel Weihenstephan, Technische Universität München, Vöttinger Str. 45, D-85350 Freising, Germany.
J Food Prot. 1997 May;60(5):493-498. doi: 10.4315/0362-028X-60.5.493.
The effect of novel food-grade long-chain polyphosphate formulations (JOHA HBS sodium polyphosphate glassy, 69 ± 1% PO, and two similar salts (HBS-1 and HBS-9) on the growth of Clostridium tyrobutyricum ATCC 25755 in liquid culture and in pasteurized, processed cheese spreads was evaluated. In broth, 0.1 % polyphosphate was sufficient to inhibit vegetative growth of the organism. In addition, a panel of 21 other gram-positive and 11 gram-negative bacteria were tested for their sensitivity against the polyphosphates. Whereas 17 of the gram-positives could be inhibited by 0.05 to 0.3% polyphosphate, none of the tested gram-negatives were affected. Two different cheese spread formulations (cheese blend A: 55% moisture, 47.2% fat in dry matter; cheese blend B: 55% moisture, 57% fat in dry matter) were fortified with 0.1 % to 1.0% polyphosphates, inoculated with 5 × 10 (cheese blend A) or 2.5 × 10 (cheese blend B) C. tyrobutyricum spores per gram, and incubated at 35°C for up to 7 weeks. Determination of viable cell counts was carried out at days 1, 9, 19, and 49 (cheese blend A) and 8, 16, 27, 35, and 50 (cheese blend B). While 0.1 % polyphosphate had little effect, higher concentrations were increasingly inhibitory to growth from a spore inoculum, to cell multiplication, and to gas formation. With 0.5% polyphosphate, onset of growth was delayed for about 3 weeks in cheese blend A, while this concentration was able to inhibit the organism in cheese blend B. In view of the experimental parameters selected (high initial contamination level; intrinsic and extrinsic parameters optimized for growth of clostridia), 0.5% polyphosphate may be sufficient to control C. tyrobutyricum growth under "normal" conditions, where initial spore counts are rather low, and storage temperatures are usually at or below 20°C. Moreover, clostridia were completely inhibited by 1.0% polyphosphate, which clearly indicated the usefulness of these polyphosphates for prevention of butyric blowing in pasteurized processed cheese spreads.
评估了新型食品级长链多磷酸盐配方(JOHA HBS 聚磷酸钠玻璃状,69 ± 1% 五氧化二磷)以及两种类似盐(HBS - 1 和 HBS - 9)对酪丁酸梭菌 ATCC 25755 在液体培养物中以及在巴氏杀菌的加工奶酪酱中的生长的影响。在肉汤中,0.1% 的多磷酸盐足以抑制该微生物的营养生长。此外,还测试了一组 21 种其他革兰氏阳性菌和 11 种革兰氏阴性菌对多磷酸盐的敏感性。17 种革兰氏阳性菌可被 0.05% 至 0.3% 的多磷酸盐抑制,而测试的革兰氏阴性菌均未受影响。两种不同的奶酪酱配方(奶酪混合物 A:水分含量 55%,干物质中脂肪含量 47.2%;奶酪混合物 B:水分含量 55%,干物质中脂肪含量 57%)添加了 0.1% 至 1.0% 的多磷酸盐,每克接种 5×10⁵(奶酪混合物 A)或 2.5×10⁵(奶酪混合物 B)个酪丁酸梭菌孢子,并在 35°C 下孵育长达 7 周。在第 1、9、19 和 49 天(奶酪混合物 A)以及第 8、16、27、35 和 50 天(奶酪混合物 B)进行活菌计数测定。虽然 0.1% 的多磷酸盐影响不大,但较高浓度对从孢子接种到细胞增殖以及气体形成的生长抑制作用越来越大。对于 0.5% 的多磷酸盐,奶酪混合物 A 中生长开始延迟约 3 周,而该浓度能够在奶酪混合物 B 中抑制该微生物。鉴于所选的实验参数(高初始污染水平;针对梭菌生长优化的内在和外在参数),0.5% 的多磷酸盐可能足以在“正常”条件下控制酪丁酸梭菌的生长,在这种条件下初始孢子计数相当低,且储存温度通常在 20°C 或以下。此外,1.0% 的多磷酸盐可完全抑制梭菌,这清楚地表明这些多磷酸盐对于防止巴氏杀菌加工奶酪酱中出现丁酸产气是有用的。