Baruffaldi Fabio, Mecca Rosaria, Stea Susanna, Beraudi Alina, Bordini Barbara, Amabile Marilina, Sudanese Alessandra, Toni Aldo
Laboratory of Medical Technology, IRCCS Istituto Ortopedico Rizzoli, Bologna, Italy.
Orthopaedics-Traumatology and Prosthetic Surgery and Revisions of Hip and Knee Replacement, IRCCS Istituto Ortopedico Rizzoli, Bologna, Italy.
Hip Int. 2020 Jul;30(4):438-445. doi: 10.1177/1120700019864233. Epub 2019 Jul 21.
Noise in ceramic-on-ceramic (CoC) total hip arthroplasty (THA) is a potential symptom of abnormal bearing wear. Squeaking and other prosthetic hip noises are multi-factorial phenomena that can be analysed and may provide prognostic information.
46 patients with noisy CoC bearings were investigated using X-ray, computed tomography and joint fluid analysis, and classified into either high or low risk of ceramic liner fracture groups according to previously published guidelines. Noise events from the bearings of 16 high risk cases which were subsequently revised were compared with 30 patients in the low risk control group who did not undergo revision. Noise events were analysed for their physical characteristics using a standardised protocol and classified as either low frequency and short duration 'clicking' or long duration and high frequency 'squeaking'.
The peak frequency of squeaking during forward walking was significantly higher for patients in the case group who were revised, compared with the control group. The patient-reported onset of squeaking (46 months postoperatively) was earlier than short-noise emissions (82 months). In the standardised sequence of movements, short-noise always occurred more frequently than squeaking. Small heads (28 mm) were more likely to develop short-noise, while large heads (⩾32 mm) were more likely to develop squeaking.
Noise evaluation may provide additional value for predicting failure of CoC bearings, though some questions should be better investigated in a dedicated prospective trial.
陶瓷对陶瓷(CoC)全髋关节置换术(THA)中的噪音是轴承异常磨损的潜在症状。吱吱声和其他人工髋关节噪音是多因素现象,可以进行分析,并可能提供预后信息。
对46例有CoC轴承噪音的患者进行了X线、计算机断层扫描和关节液分析,并根据先前发表的指南分为陶瓷衬垫骨折高风险或低风险组。将随后进行翻修的16例高风险病例的轴承噪音事件与30例未进行翻修的低风险对照组患者进行比较。使用标准化方案分析噪音事件的物理特征,并将其分类为低频短持续时间的“咔嗒声”或长持续时间高频的“吱吱声”。
与对照组相比,进行翻修的病例组患者向前行走时吱吱声的峰值频率显著更高。患者报告的吱吱声发作时间(术后46个月)早于短噪音排放时间(82个月)。在标准化的动作序列中,短噪音总是比吱吱声更频繁地出现。小头(28毫米)更有可能出现短噪音,而大头(⩾32毫米)更有可能出现吱吱声。
噪音评估可能为预测CoC轴承的失效提供额外价值,尽管一些问题应在专门的前瞻性试验中进行更好的研究。