Department of Chemical Engineering, Federal University of Pernambuco (UFPE), 1235 Prof. Moraes Rego Av., Cidade Universitária, Recife, PE, 50670-901, Brazil.
Engineering Campus-UACSA, Federal Rural University of Pernambuco (UFRPE), 300 Cento e Sessenta e Três Av, Cabo de Santo Agostinho, PE, 54518-430, Brazil.
Environ Sci Pollut Res Int. 2021 May;28(19):23684-23698. doi: 10.1007/s11356-020-10926-6. Epub 2020 Sep 29.
Multilayer graphene oxide (mGO) was synthesized and functionalized via co-precipitation method to produce magnetic FeO-functionalized multilayer graphene oxide nanocomposite (MmGO). Photocatalytic properties of MmGO were investigated in the photodegradation of raw textile wastewater samples. Fourier-transformed infrared spectroscopy revealed Fe-O vibrations, characterized by the band shift from 636.27 to 587.25 cm on MmGO. X-ray diffraction confirmed the successful oxidation of graphite by the (002) peak at 10° and indicated the presence of FeO on MmGO surface by the peaks at 2θ 35.8° (311), 42.71° (400), 54.09° (511), and 62.8° (440). There was no detection of coercivity field and remnant magnetization, evidencing a material with superparamagnetic properties. Then, the textile effluent was treated by heterogeneous photo-Fenton (HPF) reaction. A 2 factorial design was conducted to evaluate the effects of MmGO dosage and HO concentration on HPF, with color and turbidity removal as response variables. The kinetic behavior of the adsorption and HPF processes was investigated separately, in which, the equilibrium was reached within 60 and 120 min, for adsorption and HPF, respectively. Pseudo-second-order model exhibited the best fit, with COD uptake capacity at equilibrium of 4094.94 mg g, for chemical oxygen demand. The modeling of kinetics data showed that the Chan and Chu model was the most representative for HPF, with initial removal rate of 95.52 min. The removal of organic matter was 76.36% greater than that reached by conventional treatment at textile mills. The presence of FeO nanoparticles attached to MmGO surface was responsible for the increase of electron mobility and the enhancement of its photocatalytic properties. Finally, MmGO presented low phytotoxic to Cucumis sativus L. with a RGI of 0.53. These results bring satisfactory perspectives regarding further employment, on large scale, of MmGO as nanocatalyst of textile pollutants.
采用共沉淀法合成并功能化了多层氧化石墨烯(mGO),以制备磁性 FeO 功能化多层氧化石墨烯纳米复合材料(MmGO)。研究了 MmGO 在原纺织废水样品光降解中的光催化性能。傅里叶变换红外光谱显示了 Fe-O 振动,特征在于 MmGO 上的带从 636.27 到 587.25 cm 的位移。X 射线衍射通过 10°处的(002)峰证实了石墨的成功氧化,并通过 2θ 处的峰表明 MmGO 表面存在 FeO35.8°(311)、42.71°(400)、54.09°(511)和 62.8°(440)。没有检测到矫顽力场和剩余磁化强度,证明了具有超顺磁性的材料。然后,通过非均相光芬顿(HPF)反应处理纺织废水。进行了 2 因子设计,以评估 MmGO 剂量和 HO 浓度对 HPF 的影响,以去除颜色和浊度为响应变量。分别研究了吸附和 HPF 过程的动力学行为,其中,吸附和 HPF 分别在 60 和 120 min 内达到平衡。准二级模型表现出最佳拟合,平衡时对化学需氧量的吸附容量为 4094.94 mg g。动力学数据的建模表明,Chan 和 Chu 模型最能代表 HPF,初始去除率为 95.52 min。与纺织厂常规处理相比,有机物的去除率提高了 76.36%。附着在 MmGO 表面的 FeO 纳米粒子增加了电子迁移率,提高了其光催化性能。最后,MmGO 对黄瓜的植物毒性较低,相对生长指数为 0.53。这些结果为进一步在大规模生产中使用 MmGO 作为纺织污染物的纳米催化剂带来了令人满意的前景。