Department of Biotechnology and Food Technology, Faculty of Science, University of Johannesburg Doornfontein Campus, P. O. Box 17011, Gauteng, 2028, South Africa.
Department of Food Science and Technology, College of Food Science and Human Ecology, Federal University of Agriculture, Ogun State, P.M.B. 2240, Abeokuta, Nigeria.
Sci Rep. 2021 Mar 9;11(1):5450. doi: 10.1038/s41598-021-85087-8.
The physical properties and water absorption kinetics of three varieties of Mucuna beans (Mucuna pruriens, Mucuna rajada and Mucuna veracruz) were determined in this study. Physical properties including length, width, thickness, geometric mean diameter, sphericity, porosity, bulk density, area, volume and one thousand seed mass were calculated while hydration kinetics was studied by soaking Mucuna beans in water at 30 °C, 40 °C and 50 °C and measuring water uptake at 9 h interval. Peleg's equation was used to model the hydration characteristics and Arrhenius equation was used to describe the effect of temperature on Peleg's rate constant k and to obtain the activation energies for soaking. Significant variations were observed in almost all the physical properties of the different varieties, however, there were no significant differences (p < 0.05) in their thicknesses and bulk densities. The effectiveness of fit of Peleg's model (R) increased with increase in soaking temperature. Peleg's rate constant k decreased with increase in soaking temperature while k increased with temperature increase. Activation energies of Mucuna pruriens, Mucuna rajada and Mucuna veracruz were 1613.24 kJ/mol, 747.95 kJ/mol and 2743.64 kJ/mol, respectively. This study provides useful information about the properties of three varieties of Mucuna beans that could be of importance to processors and engineers for process design and optimization.
本研究旨在测定三种木豆(长叶木豆、拉贾达木豆和维拉克鲁兹木豆)的物理特性和水分吸收动力学。计算了物理特性,包括长度、宽度、厚度、几何平均直径、球形度、孔隙率、堆密度、面积、体积和千粒质量,同时通过在 30°C、40°C 和 50°C 的水中浸泡木豆并在 9 小时间隔测量水分吸收来研究水合动力学。使用 Peleg 方程对水合特性进行建模,使用阿仑尼乌斯方程描述温度对 Peleg 速率常数 k 的影响,并获得浸泡的活化能。不同品种的几乎所有物理特性都存在显著差异,但厚度和堆密度没有显著差异(p<0.05)。Peleg 模型的拟合效果(R)随着浸泡温度的升高而增加。Peleg 速率常数 k 随着浸泡温度的升高而降低,而 k 随着温度的升高而升高。木豆的活化能分别为 1613.24 kJ/mol、747.95 kJ/mol 和 2743.64 kJ/mol。本研究提供了有关三种木豆品种特性的有用信息,这些信息对于加工商和工程师进行工艺设计和优化可能很重要。