Department of Pathology, University of Utah, Salt Lake City, UT 84132, USA.
Nucleic Acids Res. 2021 May 7;49(8):4574-4585. doi: 10.1093/nar/gkab205.
We used stopped-flow to monitor hypochromicity for 43 oligonucleotide duplexes to study nucleic acid kinetics and extract transition-state parameters for association and dissociation. Reactions were performed in 1.0 M NaCl (for literature comparisons) and 2.2 mM MgCl2 (PCR conditions). Dissociation kinetics depended on sequence, increased exponentially with temperature, and transition-state parameters inversely correlated to thermodynamic parameters (r = -0.99). Association had no consistent enthalpic component, varied little with temperature or sequence, and poorly correlated to thermodynamic parameters (r = 0.28). Average association rates decreased 78% in MgCl2 compared to NaCl while dissociation was relatively insensitive to ionic conditions. A nearest-neighbour kinetic model for dissociation predicted rate constants within 3-fold of literature values (n = 11). However, a nearest-neighbour model for association appeared overparameterized and inadequate for predictions. Kinetic predictions were used to simulate published high-speed (<1 min) melting analysis and extreme (<2 min) PCR experiments. Melting simulations predicted apparent melting temperatures increase on average 2.4°C when temperature ramp rates increased from 0.1 to 32°C/s, compared to 2.8°C reported in the literature. PCR simulations revealed that denaturation kinetics are dependent on the thermocycling profile. Simulations overestimated annealing efficiencies at shorter annealing times and suggested that polymerase interactions contribute to primer-template complex stability at extension temperatures.
我们使用停流技术监测 43 个寡核苷酸双链体的低色性,以研究核酸动力学并提取结合和解离的过渡态参数。反应在 1.0 M NaCl(用于文献比较)和 2.2 mM MgCl2(PCR 条件)中进行。解离动力学取决于序列,随温度呈指数增长,过渡态参数与热力学参数呈反比(r = -0.99)。结合没有一致的焓成分,随温度或序列变化很小,与热力学参数相关性差(r = 0.28)。与 NaCl 相比,MgCl2 中的平均结合速率下降了 78%,而解离对离子条件相对不敏感。解离的最近邻动力学模型预测的速率常数与文献值相差 3 倍以内(n = 11)。然而,最近邻结合模型似乎参数过多,不适合预测。动力学预测用于模拟已发表的高速(<1 分钟)熔解分析和极端(<2 分钟)PCR 实验。熔解模拟预测,当温度 ramp 率从 0.1 增加到 32°C/s 时,表观熔解温度平均升高 2.4°C,而文献中报告的为 2.8°C。PCR 模拟表明变性动力学取决于热循环曲线。模拟在较短的退火时间高估了退火效率,并表明聚合酶相互作用有助于延伸温度下引物-模板复合物的稳定性。