Suppr超能文献

胫骨隧道的解剖位置并不能完全环绕胫骨近端模拟的后交叉韧带重建移植物。

An Anatomically Placed Tibial Tunnel does not Completely Surround a Simulated PCL Reconstruction Graft in the Proximal Tibia.

机构信息

Private Practice, Iowa Clinic, West Des Moines, Iowa.

Department of Orthopedic Surgery, Saint Louis University, Saint Louis, Missouri.

出版信息

J Knee Surg. 2023 Jun;36(7):725-730. doi: 10.1055/s-0041-1741430. Epub 2022 Jan 3.

Abstract

INTRODUCTION

It is hypothesized that anatomic tunnel placement will create tunnels with violation of the posterior cortex and subsequently an oblique aperture that is not circumferentially surrounded by bone. In this article, we aimed to characterize posterior cruciate ligament (PCL) tibial tunnel using a three-dimensional (3D) computed tomography (CT) model.

METHODS

Ten normal knee CTs with the patella, femur, and fibula removed were used. Simulated 11 mm PCL tibial tunnels were created at 55, 50, 45, and 40 degrees. The morphology of the posterior proximal tibial exit was examined with 3D modeling software. The length of tunnel not circumferentially covered (cortex violation) was measured to where the tibial tunnel became circumferential. The surface area and volume of the cylinder both in contact with the tibial bone and that not in contact with the tibia were determined. The percentages of the stick-out length surface area and volume not in contact with bone were calculated.

RESULTS

The mean stick-out length of uncovered graft at 55, 50, 45, and 40 degrees were 26.3, 20.5, 17.3, and 12.7 mm, respectively. The mean volume of exposed graft at 55, 50, 45, and 40 degrees were 840.8, 596.2, 425.6, and 302.9 mm, respectively. The mean percent of volume of exposed graft at 55, 50, 45, and 40 degrees were 32, 29, 25, and 24%, respectively. The mean surface of exposed graft at 55, 50, 45, and 40 degrees were 372.2, 280.4, 208.8, and 153.3 mm, respectively. The mean percent of surface area of exposed graft at 55, 50, 45, and 40 degrees were 40, 39, 34, and 34%, respectively.

CONCLUSION

Anatomic tibial tunnel creation using standard transtibial PCL reconstruction techniques consistently risks posterior tibial cortex violation and creation of an oblique aperture posteriorly. This risk is decreased with decreasing the angle of the tibial tunnel, though the posterior cortex is still compromised with angles as low as 40 degrees. With posterior cortex violation, a surgeon should be aware that a graft within the tunnel or socket posteriorly may not be fully in contact with bone. This is especially relevant with inlay and socket techniques.

摘要

简介

有人假设解剖学隧道位置会导致隧道穿透后皮质,并随后形成一个非环形骨包围的斜形隧道口。本文旨在使用三维(3D)计算机断层扫描(CT)模型来描述后交叉韧带(PCL)胫骨隧道。

方法

使用 10 个去除髌骨、股骨和腓骨的正常膝关节 CT。在 55、50、45 和 40 度创建模拟的 11mm PCL 胫骨隧道。使用 3D 建模软件检查胫骨近端后出口的形态。测量未环形覆盖(皮质穿透)的隧道长度,直到隧道成为环形。确定与胫骨接触和不与胫骨接触的圆柱的表面积和体积。计算未接触骨的钉突长度表面积和体积的百分比。

结果

55、50、45 和 40 度时,未覆盖移植物的平均钉突长度分别为 26.3、20.5、17.3 和 12.7mm。55、50、45 和 40 度时,暴露移植物的平均体积分别为 840.8、596.2、425.6 和 302.9mm。55、50、45 和 40 度时,暴露移植物体积的平均百分比分别为 32%、29%、25%和 24%。55、50、45 和 40 度时,暴露移植物的平均表面积分别为 372.2、280.4、208.8 和 153.3mm。55、50、45 和 40 度时,暴露移植物表面积的平均百分比分别为 40%、39%、34%和 34%。

结论

使用标准经胫骨 PCL 重建技术进行解剖学胫骨隧道创建始终存在穿透后胫骨皮质并在后部形成斜形隧道口的风险。随着胫骨隧道角度的降低,这种风险会降低,尽管即使角度低至 40 度,后皮质仍会受到影响。后皮质穿透后,外科医生应该意识到隧道或插座内的移植物可能无法与骨骼完全接触。这在嵌体和插座技术中尤为重要。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验