Suppr超能文献

减少冲洗公共厕所时产生的颗粒。

Reducing the particles generated by flushing institutional toilets.

机构信息

Department of Occupational and Environmental Health, Hudson College of Public Health, The University of Oklahoma Health Sciences Center, The University of Oklahoma, Oklahoma City, Oklahoma.

Applied Research and Technology, National Institute for Occupational Safety and Health (Retired), Washington, District of Columbia.

出版信息

J Occup Environ Hyg. 2022 May;19(5):318-326. doi: 10.1080/15459624.2022.2053693. Epub 2022 Apr 19.

Abstract

Airborne particles play a significant role in the transmission of SARS-CoV-2, the virus that causes COVID-19. A previous study reported that institutional flush-O-meter (FOM) toilets can generate 3-12 times as many droplets as other toilets by splashing (large droplets) and bubble bursting (fine droplets). In this study, an aerosol suppression lid was evaluated to measure the reduction of particles by size using three metrics; number, surface area, and mass concentrations. To quantify toilet flush aerosol over time, detailed particle size distributions (from 0.016-19.81 µm across 152 size bins) were measured from a FOM toilet in a controlled-environment test chamber, without ventilation, with and without use of the suppression lid. Prior to each flushing trial, the toilet bowl water was seeded with 480 mL fluorescein at 10 mg/mL. A high-speed camera was used to record the large droplet movements after flushing. An ultraviolet-visible spectrophotometer was used to analyze the wipe samples to evaluate the contamination on the lid. The particle number, surface area, and mass concentrations without a lid were elevated compared to a lid in the first 90 sec. Overall, the lid reduced 48% of total number concentration, 76% of total surface area concentration, and 66% of total mass concentration, respectively. Depending on the particle size, the number concentration reduction percentage ranged from 48-100% for particles larger than 0.1 µm. Large droplets created by splashing were captured by the high-speed camera. Similar studies can be used for future particle aerodynamic studies. The fluorescein droplets deposited on the lid back sections, which were closer to the FOM accounted for 82% of the total fluorescein. Based on two-way ANOVA analysis, there were significant differences among both the experimental flushes ( = 0.0185) and the sections on the lid ( = 0.0146). Future work should explore the aerosolization produced by flushing and the performance of the lid in real restroom environments, where feces and urine exist in the bowl water and the indoor ventilation system is in operation.

摘要

空气中的颗粒在 SARS-CoV-2(导致 COVID-19 的病毒)的传播中起着重要作用。先前的一项研究报告称,机构冲洗-O-米(FOM)马桶通过溅水(大液滴)和气泡破裂(小液滴)可以产生比其他马桶多 3-12 倍的液滴。在这项研究中,评估了气溶胶抑制盖,以使用三个指标(数量、表面积和质量浓度)来测量大小的颗粒减少。为了量化随时间推移的马桶冲洗气溶胶,在没有通风的情况下,在受控环境测试室中使用 FOM 马桶,使用和不使用抑制盖,从 152 个尺寸的细颗粒尺寸分布(从 0.016-19.81μm 跨越 152 个尺寸的细颗粒尺寸分布)中测量了详细的颗粒尺寸分布。在每次冲洗试验之前,马桶水箱中用 10mg/mL 的浓度注入了 480mL 荧光素。高速摄像机用于记录冲洗后的大液滴运动。使用紫外可见分光光度计分析擦拭样品,以评估盖子上的污染情况。与盖子相比,无盖时的颗粒数量、表面积和质量浓度在前 90 秒内升高。总体而言,盖子分别减少了总数量浓度的 48%、总表面积浓度的 76%和总质量浓度的 66%。根据颗粒尺寸,对于大于 0.1μm 的颗粒,数量浓度减少百分比范围为 48-100%。高速摄像机捕获了由溅水产生的大液滴。类似的研究可用于未来的颗粒空气动力学研究。荧光素液滴沉积在盖子的后段,这些后段更靠近 FOM,占总荧光素的 82%。基于双向方差分析,两种实验冲洗( =0.0185)和盖子上的部分( =0.0146)之间存在显著差异。未来的工作应该探索冲洗产生的气溶胶化和盖子在真实浴室环境中的性能,在这种环境中,粪便和尿液存在于马桶水箱中,室内通风系统正在运行。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验