Department of Accelerator Science, Korea University Sejong Campus, Sejong, Republic of Korea.
Department of Biomedical Engineering, College of Medicine, Catholic University of Korea, Seoul, Republic of Korea.
Med Phys. 2023 Jun;50(6):3816-3824. doi: 10.1002/mp.16242. Epub 2023 Feb 7.
The machine-specific reference (msr) correction factors ( ) were introduced in International Atomic Energy Agency (IAEA) Technical Report Series 483 (TRS-483) for reference dosimetry of small fields. Several correction factor sets exist for a Leksell Gamma Knife (GK) Perfexion or Icon. Nevertheless, experiments have not rigorously validated the correction factors from different studies.
This study aimed to assess the role and accuracy of values in determining the absorbed dose rates to water in the reference dosimetry of Gamma Knife.
The dose rates in the 16 mm collimator field of a GK were determined following the international code of practices with three ionization chambers: PTW T31010, PTW T31016 (PTW Freiberg GmbH, New York, NY), and Exradin A16 (Standard Imaging, Inc., Middleton, WI). A chamber was placed at the center of a solid water phantom (Elekta AB, Stockholm, Sweden) using a detector-specific insert. The reference point of the ionization chamber was confirmed using cone-beam CT images. Consistency checks were repeated five times at a GK site and performed once at seven GK sites. Correction factors from six simulations reported in previous studies were employed. Variations in the dose rates and relative dose rates before and after applying the were statistically compared.
The standard deviation of the dose rates measured by the three chambers decreased significantly after any correction method was applied (p = 0.000). When the correction factors of all studies were averaged, the standard deviation was reduced significantly more than when any single correction method was applied (p ≤ 0.030), except for the IAEA TRS-483 correction factors (p = 0.148). Before any correction was applied, there were statistically significant differences among the relative dose rates measured by the three chambers (p = 0.000). None of the single correction methods could remove the differences among the ionization chambers (p ≤ 0.038). After TRS-483 correction, the dose rate of Exradin A16 differed from those of the other two chambers (p ≤ 0.025). After the averaged factors were applied, there were no statistically significant differences between any pairs of chambers according to Scheffe's post hoc analyses (p ≥ 0.051); however, PTW T31010 differed from PTW 31016 according to Tukey's HSD analyses (p = 0.040).
The significantly reduced variations in the dose rates measured by the three ionization chambers. The mean correction factors of the six simulations produced the most consistent results, but this finding was not explicitly proven in the statistical analyses.
国际原子能机构技术报告系列 483(TRS-483)引入了机器特定参考(msr)校正因子( ),用于小场的参考剂量测定。对于 Leksell Gamma Knife(GK)Perfexion 或 Icon,存在多个校正因子集。然而,实验并未严格验证来自不同研究的校正因子。
本研究旨在评估 值在确定 Gamma Knife 参考剂量测定中水吸收剂量率中的作用和准确性。
使用三个电离室:PTW T31010、PTW T31016(PTW Freiberg GmbH,纽约,NY)和 Exradin A16(Standard Imaging,Inc., Middleton,WI),按照国际实践规范确定 GK 的 16mm 准直器场中的剂量率。将一个探测器专用插件放置在 Elekta AB(斯德哥尔摩,瑞典)的固体水体模的中心。使用锥形束 CT 图像确认电离室的参考点。在 GK 站点重复进行五次一致性检查,并在七个 GK 站点进行一次。采用了先前研究中报告的六个模拟的校正因子。在应用 前后,对剂量率和相对剂量率的变化进行了统计学比较。
应用任何校正方法后,三个电离室测量的剂量率的标准偏差显著降低(p=0.000)。当平均所有研究的校正因子时,标准偏差的降低幅度明显大于应用任何单个校正方法时(p≤0.030),除了国际原子能机构 TRS-483 校正因子(p=0.148)。在应用任何校正之前,三个电离室测量的相对剂量率之间存在统计学显著差异(p=0.000)。任何单个校正方法都无法消除电离室之间的差异(p≤0.038)。在 TRS-483 校正后,Exradin A16 的剂量率与其他两个腔室的剂量率不同(p≤0.025)。在应用平均因子后,根据 Scheffe 的事后分析,任何两个腔室之间没有统计学上显著的差异(p≥0.051);然而,根据 Tukey 的 HSD 分析,PTW T31010 与 PTW T31016 不同(p=0.040)。
值显著降低了三个电离室测量的剂量率的变化。六个模拟的平均校正因子产生了最一致的结果,但这一发现并未在统计分析中明确证明。