Gül Latife Betül, Bekbay Saya, Akgün Abdullah, Gül Osman
Department of Food Engineering Faculty of Engineering Giresun University Giresun Turkey.
Department of Food Technology and Processing Products Technical Faculty Saken Seifullin Kazakh AgroTechnical Research University Nur-Sultan (Astana) Kazakhstan.
Food Sci Nutr. 2023 Jun 9;11(9):5325-5337. doi: 10.1002/fsn3.3491. eCollection 2023 Sep.
In this study, the effects of peeled oleaster flour (OF) addition (0.5% and 1%) with high-pressure homogenization (HPH) at 100 MPa on acidification kinetics, physicochemical, functional, and rheological properties of kefir made from bovine whole milk were investigated. The fermentation kinetic parameters such as and decreased by 23.63% and 20%, respectively, with 1% OF and application of HPH. The combined use of two treatments had a positive effect on and counts, reaching a maximum of 9.63 and 9.31 log cfu/mL, respectively. Also, total phenolic contents and antioxidant activity reached maximum values of 85.31 mg GAE/g and 17.22%, respectively. The value was more limited with HPH. The maximum firmness and water-holding capacity values were determined in the sample produced with 1% OF and application of HPH. Rheological analysis revealed that all kefirs exhibited shear thinning behavior, and the Ostwald-de-Waele ( > .99) model was suitable to describe the rheological behavior of all kefir samples. The highest viscosity (0.049 Pa.s, at 50/s shear rate) and consistency index (1.115 Pa.s) were observed in kefir with 1% OF and application of HPH. Kefir samples were characterized as weak gel behavior because storage modulus (G') was much greater than loss modulus (G") and the power-law model was used to characterize the viscoelasticity. The overall quality assessment indicated that the improvement of the fermentation process and the enhancement of textural and functional properties of kefir samples could be achieved with the addition of 1% OF and application of HPH.
在本研究中,研究了添加去皮沙棘粉(OF)(0.5%和1%)并在100兆帕压力下进行高压均质处理(HPH)对全脂牛乳发酵乳的酸化动力学、理化性质、功能特性和流变学性质的影响。发酵动力学参数,如 和 ,在添加1%OF并进行HPH处理时分别降低了23.63%和20%。两种处理方法的联合使用对 和 计数有积极影响,分别达到最大值9.63和9.31 log cfu/mL。此外,总酚含量和抗氧化活性分别达到最大值85.31毫克没食子酸当量/克和17.22%。HPH处理时 值更受限。在添加1%OF并进行HPH处理的样品中测定出最大硬度和持水能力值。流变学分析表明,所有发酵乳均表现出剪切变稀行为,奥斯特瓦尔德-德瓦勒模型( >0.99)适合描述所有发酵乳样品的流变学行为。在添加1%OF并进行HPH处理的发酵乳中观察到最高粘度(在50/s剪切速率下为0.049帕·秒)和稠度指数(1.115帕·秒)。发酵乳样品表现为弱凝胶行为,因为储能模量(G')远大于损耗模量(G"),且幂律模型用于表征粘弹性。总体质量评估表明,添加1%OF并进行HPH处理可改善发酵过程,并增强发酵乳样品的质地和功能特性。