School of Chemistry and Environmental Engineering, Changchun University of Science and Technology, Changchun 130022, PR China.
School of Chemistry and Environmental Engineering, Changchun University of Science and Technology, Changchun 130022, PR China.
Waste Manag. 2024 May 30;181:34-43. doi: 10.1016/j.wasman.2024.03.027. Epub 2024 Apr 5.
The main disposal method for municipal solid waste (MSW), including the growing worldwide volumes of kitchen waste, involves transport to landfills. Because kitchen waste is mainly composed of organic matter and has a high moisture content, large amounts of leachate and landfill gas are generated when it is sent to landfills. Therefore, rapid waste stabilization is essential. In this study, four semi-aerobic bioreactors (named NS, SS, MS, and LS) were established with void fractions of 33.76%, 39.84%, 44.62%, and 41.31%, respectively. The results showed that the void fractions of landfill directly affected the gas flow path. When the landfill void fraction was small (e.g., NS), most airflow traveled directly through the pipeline and minimal airflow entered the waste layer. When the landfill void fraction was large (e.g., MS), air easily entered the waste layer and some air flowed into the gas vent with the landfill gas. As the reaction proceeded, the void fraction gradually decreased due to gravity-induced sedimentation. During the water addition experiment, the voids were occupied by water, leading to formation of an anaerobic area. Among the four bioreactors, only MS had negligible formation of an anaerobic zone in the center. Methane (CH) generation was detected only at the connection between the gas vent and the leachate collection pipe. A larger void fraction led to formation of a smaller anaerobic zone. The ratio of air flowing in pipeline was lowest in MS. These results indicated that a large void fraction promotes the decomposition of organic matter.
城市固体废物(MSW)的主要处理方法,包括日益增长的厨余垃圾量,涉及到运往垃圾填埋场。由于厨余垃圾主要由有机物组成,且含水量高,因此送到垃圾填埋场时会产生大量渗滤液和填埋气。因此,快速实现废物稳定化至关重要。在这项研究中,建立了四个半好氧生物反应器(分别命名为 NS、SS、MS 和 LS),其空隙率分别为 33.76%、39.84%、44.62%和 41.31%。结果表明,填埋场的空隙率直接影响气体流动路径。当填埋场空隙率较小时(如 NS),大部分气流直接通过管道,很少有气流进入废物层。当填埋场空隙率较大时(如 MS),空气容易进入废物层,部分空气随填埋气进入气体出口。随着反应的进行,由于重力沉降,空隙率逐渐减小。在加水实验中,空隙被水占据,导致形成厌氧区。在四个生物反应器中,只有 MS 在中心区域几乎没有形成厌氧区。仅在气体出口和渗滤液收集管之间检测到甲烷(CH)生成。较大的空隙率会形成较小的厌氧区。在 MS 中,进入管道的空气比例最低。这些结果表明,较大的空隙率有助于有机物的分解。