Suppr超能文献

氧化铁颜料粉末对大气成分的表面反应性:X射线光电子能谱、场发射扫描电子显微镜以及一氧化碳和二氧化碳吸附的重量测定法

Surface Reactivity of Iron Oxide Pigmentary Powders toward Atmospheric Components: XPS, FESEM, and Gravimetry of CO and CO2 Adsorption.

作者信息

Ismail HM, Cadenhead DA, Zaki MI

机构信息

Department of Chemistry, State University of New York at Buffalo, Buffalo, New York, 14260-3000

出版信息

J Colloid Interface Sci. 1997 Oct 15;194(2):482-8. doi: 10.1006/jcis.1997.5128.

Abstract

The adsorption of carbon monoxide and carbon dioxide (CO and CO2) on a number of specially prepared alpha-Fe2O3 samples was measured gravimetrically at 25°C. The samples were prepared from a steel-pickling waste (97 wt% FeSO4·7H2O) by roasting the original material at 700°C for 5 h in air, oxygen, and nitrogen. Estimated surface coverages by the adsorbed CO and CO2 were made on the basis of nitrogen-adsorption-based surface areas, while the nature of the sample surfaces was investigated by both X-ray photoelectron spectroscopy (XPS) and field emission SEM (FESEM) techniques. In addition a depth profiling study utilizing a sputtering argon beam and XPS was undertaken. Morphological studies using FESEM showed that neither CO nor CO2 caused any significant structural changes. The nature of the resultant alpha-Fe2O3 sample surfaces differed, with the degree of oxygenation decreasing in the order of preparatory gases: oxygen, (wet) air, nitrogen [IP(O), IP(A), and IP(N)]. The amounts of both CO and CO2 adsorbed decreased in the sample order IP(A) > IP(O) > IP(N), though in the case of CO adsorption, the amounts adsorbed on IP(A) and IP(O) were not greatly different. In all cases the amounts adsorbed represented only fractional coverage. Adsorption of the more acidic CO2 is thought to be favored more by basic Ox-2 than by O2- sites on both IP(O) and IP(A), but with surface hydroxyl groups also playing a role (particularly on IP(A)). The CO2 adsorption should result in the formation of mono-, di-, and polydentate carbonate and bicarbonate species, with increasing degassing temperatures favoring the polydentate species and the decomposition of the bicarbonate and carbonate to form undissociated CO2. The adsorption of CO (a weak base) is postulated to take place on strong Lewis acid, highly coordinated, metal sites to form metal carbonyl species, on strong base sites (O2-) to form carbonite, oxalate, and ketenic species, and, to a lesser degree, on surface hydroxyl groups to form formyl and formate species. Copyright 1997 Academic Press. Copyright 1997Academic Press

摘要

在25℃下,采用重量法测定了一氧化碳和二氧化碳(CO和CO2)在一些特殊制备的α-Fe2O3样品上的吸附情况。这些样品由钢酸洗废料(97 wt% FeSO4·7H2O)制备而成,通过在空气、氧气和氮气中于700℃焙烧原材料5小时得到。基于氮气吸附法测定的表面积估算了吸附的CO和CO2的表面覆盖度,同时利用X射线光电子能谱(XPS)和场发射扫描电子显微镜(FESEM)技术研究了样品表面的性质。此外,还利用溅射氩离子束和XPS进行了深度剖析研究。使用FESEM进行的形态学研究表明,CO和CO2均未引起任何显著的结构变化。所得α-Fe2O3样品表面的性质有所不同,氧化程度按制备气体顺序降低:氧气、(湿)空气、氮气[IP(O)、IP(A)和IP(N)]。CO和CO2的吸附量均按IP(A) > IP(O) > IP(N)的样品顺序降低,不过就CO吸附而言,IP(A)和IP(O)上的吸附量差异不大。在所有情况下,吸附量仅代表部分覆盖度。认为在IP(O)和IP(A)上,酸性更强的CO2在碱性的Ox-2位点上比在O2-位点上更易吸附,但表面羟基也起作用(特别是在IP(A)上)。CO2吸附应导致形成单齿、双齿和多齿碳酸盐及碳酸氢盐物种,脱气温度升高有利于多齿物种以及碳酸氢盐和碳酸盐分解形成未解离的CO2。推测CO(一种弱碱)在强路易斯酸、高配位的金属位点上吸附形成金属羰基物种,在强碱位点(O2-)上形成碳酸盐、草酸盐和烯酮物种,在较小程度上在表面羟基上形成甲酰基和甲酸盐物种。版权所有1997年学术出版社。版权所有1997年学术出版社

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验