Nag K, Munro J G, Hearn S A, Rasmusson J, Petersen N O, Possmayer F
Department of Obstetrics & Gynecology, University of Western Ontario, London, Ontario, N5X 2L9, Canada.
J Struct Biol. 1999 Jun 1;126(1):1-15. doi: 10.1006/jsbi.1999.4089.
Pulmonary surfactant stabilizes the lung by reducing surface tension at the air-water interface of the alveoli. Surfactant is present in the lung in a number of morphological forms, including tubular myelin (TM). TM is composed of unusual 40 x 40 nm square elongated proteolipid tubes. Atomic force microscopy (AFM) was performed on polymer-embedded Lowicryl and London Resin-White (LR-White) unstained thin sections. AFM was used in imaging regions of the sections where TM was detected by transmission electron microscopy (EM) of corresponding stained sections. Tapping- and contact-mode AFM imaging of the unstained sections containing TM indicated a highly heterogeneous surface topography with height variations ranging from 10 to 100 nm. In tapping-mode AFM, tubular myelin was seen as hemispherical protrusions of 30-70 nm in diameter, with vertical dimensions of 5-8 nm. In contact-mode AFM and with phase imaging using a sharper (>10 nm nominal radius) probe, square open-ended tubes which resembled typical electron micrographs of such regions were observed. The cross-hatch structures observed inside the tubes using EM were not observed using AFM, although certain multilobe structures and topographic heterogeneity were detected inside some tubes. Other regions of multilamellar bodies and some regions where such bilayer lamella appear to fuse with the tubes were found in association with TM using AFM. EM of acetone-delipidated tubes in LR-White revealed rectangular tubular cores containing cross-hatched structures, presumably protein skeletons. AFM surface topography of these regions showed hollow depressions at positions at which the protein was anticipated instead of the protrusions seen in the lipid-containing sections. Gold-labeled antibody to surfactant protein A was found associated somewhat randomly within the regions containing the protein skeletons. The topography of the gold particles was observed as sharp peaks in contact-mode AFM. This study suggests a method for unambiguous detection of three-dimensional nanotubes present in low abundance in a biological macromolecular complex. Only limited detection of proteins and lipids in surfaces of embedded tubular myelin was possible. EM and AFM imaging of such unusual biological structures may suggest unique lipid-protein associations and arrangements in three dimensions.
肺表面活性剂通过降低肺泡气-水界面的表面张力来稳定肺。表面活性剂在肺中以多种形态存在,包括管状髓磷脂(TM)。TM由不同寻常的40×40纳米方形细长蛋白脂质管组成。对包埋在聚合物中的Lowicryl和伦敦树脂白(LR-White)未染色薄切片进行了原子力显微镜(AFM)检测。AFM用于对相应染色切片经透射电子显微镜(EM)检测到TM的切片区域进行成像。对含有TM的未染色切片进行轻敲模式和接触模式AFM成像,结果显示表面形貌高度不均一,高度变化范围为10至100纳米。在轻敲模式AFM中,管状髓磷脂表现为直径30 - 70纳米的半球形突起,垂直尺寸为5 - 8纳米。在接触模式AFM中,使用更尖锐(标称半径>10纳米)的探针进行相成像时,观察到了类似此类区域典型电子显微镜照片的方形开口管。尽管在一些管内检测到了某些多叶结构和形貌不均一性,但使用AFM未观察到在EM下管内所见的交叉条纹结构。使用AFM发现多板层体的其他区域以及一些双层薄片似乎与管融合的区域与TM相关。对LR-White中丙酮脱脂管的EM分析显示,矩形管状核心含有交叉条纹结构,推测为蛋白质骨架。这些区域的AFM表面形貌在预期蛋白质所在位置显示出空心凹陷,而非含脂质切片中所见的突起。发现抗表面活性蛋白A的金标记抗体在含有蛋白质骨架的区域内分布有些随机。在接触模式AFM中,金颗粒的形貌表现为尖锐峰。本研究提出了一种明确检测生物大分子复合物中低丰度存在的三维纳米管的方法。在包埋的管状髓磷脂表面仅能有限地检测到蛋白质和脂质。对这种异常生物结构的EM和AFM成像可能揭示三维空间中独特的脂质-蛋白质关联及排列。