Franssen O, Stenekes R J, Hennink W E
Department of Pharmaceutics, Utrecht Institute of Pharmaceutical Sciences (UIPS), Faculty of Pharmacy, Universiteit Utrecht, P.O. Box 80.082, 3508 TB, Utrecht, Netherlands.
J Control Release. 1999 May 20;59(2):219-28. doi: 10.1016/s0168-3659(98)00193-x.
Protein-loaded dextran microspheres were prepared by a water-in-water emulsion technique. With this technique, an aqueous solution of methacrylated dextran (dex-MA) is emulsified in an aqueous solution of poly(ethylene glycol) (PEG). Subsequently, the dispersed dex-MA phase is crosslinked by radical polymerization of the dextran-bound methacryloyl groups. This method renders microspheres with a hydrogel character of which the crosslink density can be controlled by the water content and the degree of substitution of the dex-MA (DS, the number of methacrylates per 100 glucopyranose residues). If an IgG solution was added to the dex-MA/PEG aqueous system prior to the polymerization reaction, the protein could be encapsulated in the dextran microspheres with a high yield (88-98%). The release of IgG was studied as a function of the water content, the DS and the degradation rate of the microspheres. The microspheres were rendered degradable by co-encapsulation of an endo-dextranase. Non-degrading microspheres mainly showed a burst release, which decreased with increasing crosslink density. By either a low water content (50%, w/w, or lower) or a high DS (DS 13), it was possible to reduce the burst release to about 10%, meaning that almost complete entrapment of the protein could be achieved. The release of IgG from degrading microspheres was predominantly dependent on the DS and the amount of encapsulated dextranase. No differences in release of IgG from microspheres with and without dextranase were observed at high DS (DS 13). This was ascribed to the inability of the enzyme to degrade these microspheres. On the other hand, the entrapped protein was completely released from enzymatically degrading microspheres with a DS 4. Moreover, the release rate of IgG was proportional to the degradation rate of these microspheres (depending on the amount of co-encapsulated dextranase). Interestingly, an almost zero-order release was observed from these microspheres for periods up to 30 days.
通过水包水乳液技术制备了负载蛋白质的葡聚糖微球。采用该技术,将甲基丙烯酸化葡聚糖(dex-MA)的水溶液在聚乙二醇(PEG)水溶液中乳化。随后,通过葡聚糖结合的甲基丙烯酰基团的自由基聚合使分散的dex-MA相交联。该方法制备的微球具有水凝胶特性,其交联密度可通过含水量和dex-MA的取代度(DS,每100个吡喃葡萄糖残基的甲基丙烯酸酯数量)来控制。如果在聚合反应之前将IgG溶液添加到dex-MA/PEG水体系中,蛋白质可以以高产率(88-98%)封装在葡聚糖微球中。研究了IgG的释放与含水量、DS和微球降解速率的关系。通过共包封内切葡聚糖酶使微球具有可降解性。非降解微球主要表现为突释,随着交联密度的增加而降低。通过低含水量(50%,w/w或更低)或高DS(DS 13),可以将突释降低到约10%,这意味着几乎可以实现蛋白质的完全包封。降解微球中IgG的释放主要取决于DS和包封的葡聚糖酶的量。在高DS(DS 13)时,未观察到有和没有葡聚糖酶的微球在IgG释放上的差异。这归因于酶无法降解这些微球。另一方面,包封的蛋白质从DS为4的酶促降解微球中完全释放。此外,IgG的释放速率与这些微球的降解速率成正比(取决于共包封的葡聚糖酶的量)。有趣的是,在长达30天的时间里,从这些微球中观察到几乎是零级释放。