Suppr超能文献

24小时内口腔温度变化

Intra-oral temperature variation over 24 hours.

作者信息

Moore R J, Watts J T, Hood J A, Burritt D J

机构信息

Department of Oral Sciences, School of Dentistry, University of Otago, New Zealand.

出版信息

Eur J Orthod. 1999 Jun;21(3):249-61. doi: 10.1093/ejo/21.3.249.

Abstract

This study aimed to investigate temperature variation at archwire sites adjacent to the maxillary right central incisor and first premolar, its correlation with ambient temperature, and the influence of inter-racial variation. Twenty young adult male subjects were randomly selected (13 Asian, seven Caucasian). Thermocouples were attached to the labial archwire component of custom-made orthodontic retainers at the two intra-oral sites. A third thermocouple measured ambient temperature. A data-logger recorded temperatures at 5-second intervals over a 24-hour period. Temperatures ranged from 5.6 to 58.5 degrees C at the incisor and from 7.9 to 54 degrees C at the premolar, with medians of 34.9 degrees C and 35.6 degrees C, respectively. Ambient temperature correlated poorly with the intra-oral temperatures. The Asian and Caucasian groups had significantly different temperature distributions. On average during the 24-hour period, temperatures at the incisor site were in the range of 33-37 degrees C for 79 per cent of the time, below it for 20 per cent, and above it for only 1 per cent of the time. Corresponding figures for the premolar site were 92, 6, and 2 per cent. At both archwire sites the most frequent temperatures were in the range of 35-36 degrees C. The data presented demonstrate that the temperature at sites on an archwire in situ varies considerably over a 24-hour period and that racial differences may exist. This information should be considered during the manufacture and use of temperature-sensitive orthodontic materials, in particular nickel-titanium archwires and springs.

摘要

本研究旨在调查上颌右中切牙和第一前磨牙附近弓丝部位的温度变化、其与环境温度的相关性以及种族差异的影响。随机选取了20名年轻成年男性受试者(13名亚洲人,7名高加索人)。将热电偶连接到定制正畸保持器的唇侧弓丝部件上的两个口腔内部位。第三个热电偶测量环境温度。数据记录器在24小时内每隔5秒记录一次温度。切牙部位的温度范围为5.6至58.5摄氏度,前磨牙部位为7.9至54摄氏度,中位数分别为34.9摄氏度和35.6摄氏度。环境温度与口腔内温度的相关性较差。亚洲组和高加索组的温度分布有显著差异。在24小时期间,平均而言,切牙部位的温度在33 - 37摄氏度范围内的时间占79%,低于该范围的时间占20%,高于该范围的时间仅占1%。前磨牙部位的相应数字分别为92%、6%和2%。在两个弓丝部位,最常见的温度范围是35 - 36摄氏度。所呈现的数据表明,原位弓丝部位的温度在24小时内变化很大,并且可能存在种族差异。在制造和使用温度敏感的正畸材料,特别是镍钛弓丝和弹簧时,应考虑这些信息。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验