Schlegel ML, Charlet L, Manceau A
LGIT-IRIGM, University of Grenoble, Grenoble Cedex 9, F-38 041, France
J Colloid Interface Sci. 1999 Dec 15;220(2):392-405. doi: 10.1006/jcis.1999.6538.
The mechanism of Co uptake from aqueous solution onto hectorite (a magnesian smectite) and its impact on the stability of this clay mineral were investigated as a function of Co concentration (TotCo = 20 to 200 µM, 0.3 M NaNO(3)) and ionic strength (0.3 and 0.01 M NaNO(3), TotCo = 100 µM) by combining kinetics measurements and Co K-edge extended X-ray absorption fine structure (EXAFS) spectroscopy. The morphology of the sorbent phase was characterized by atomic force microscopy (AFM) and consists of lath-type particles bounded by large basal planes and layer edges. At low ionic strength (0.01 M NaNO(3)), important Co uptake occurred within the first 5 min of reaction, consistent with Co adsorption on exchange sites of hectorite basal planes. Thereafter, the sorption rate dramatically decreased. In contrast, at high ionic strength (0.3 M NaNO(3)), Co uptake rate was much slower within the first 5 min and afterward higher than at 0.01 M NaNO(3), consistent with Co adsorption on specific surface sites located on the edges of hectorite. Time-dependent isotherms for Co uptake at high ionic strength indicated the existence of several sorption mechanisms having distinct equilibration times. The dissolution of hectorite was monitored before and after Co addition. A congruent dissolution regime was observed prior to Co addition. Just after Co addition, an excess release of Mg relatively to congruent dissolution rates occurred at both high and low ionic strengths. At high ionic strength, this excess release nearly equaled the amount of sorbed Co. The dissolution rate of hectorite then decreased at longer Co sorption times. EXAFS spectra of hectorite reacted with Co at high and low ionic strengths and for reaction times longer than 6 h, exhibited similar features, suggesting that the local structural environments of Co atoms are similar. Spectral simulations revealed the occurrence of approximately 2 Mg and approximately 2 Si neighboring cations at interatomic distances characteristic of edge-sharing linkages between Co and Mg octahedra and corner-sharing linkages between Co octahedra and Si tetrahedra, respectively. This local structure is characteristic of inner sphere mononuclear surface complexes at layer edges of hectorite platelets. The occurrence of these complexes even at low ionic strength apparently conflicts with kinetics results, as exchangeable divalent cations are known to form outer sphere surface complexes. To clarify this issue, the amount of Co adsorbed on exchange sites was calculated from the solute Co concentration, assuming that cation exchange was always at equilibrium. These calculations showed that sorbed Co was transferred within 48 h from exchange sites to edge sorption sites. Copyright 1999 Academic Press.
通过结合动力学测量和钴K边扩展X射线吸收精细结构(EXAFS)光谱,研究了水溶液中钴在锂蒙脱石(一种镁质蒙脱石)上的吸附机制及其对这种粘土矿物稳定性的影响,该研究考察了钴浓度(总钴=20至200μM,0.3M硝酸钠)和离子强度(0.3和0.01M硝酸钠,总钴=100μM)的作用。吸附剂相的形态通过原子力显微镜(AFM)进行表征,由由大基面和层边缘界定的板条型颗粒组成。在低离子强度(0.01M硝酸钠)下,重要的钴吸附在反应的前5分钟内发生,这与钴在锂蒙脱石基面交换位点上的吸附一致。此后,吸附速率急剧下降。相比之下,在高离子强度(0.3M硝酸钠)下,钴的吸附速率在前5分钟内要慢得多,之后高于0.01M硝酸钠时的速率,这与钴在锂蒙脱石边缘特定表面位点上的吸附一致。高离子强度下钴吸附的时间依赖性等温线表明存在几种具有不同平衡时间的吸附机制。在添加钴之前和之后监测锂蒙脱石的溶解情况。在添加钴之前观察到一致的溶解状态。刚添加钴后,在高离子强度和低离子强度下都出现了相对于一致溶解速率过量释放的镁。在高离子强度下,这种过量释放几乎等于吸附的钴的量。然后在更长的钴吸附时间下,锂蒙脱石的溶解速率下降。在高离子强度和低离子强度下以及反应时间超过6小时后与钴反应的锂蒙脱石的EXAFS光谱表现出相似的特征,表明钴原子周围的局部结构环境相似。光谱模拟显示,分别在钴与镁八面体之间的边共享键以及钴八面体与硅四面体之间的角共享键的特征原子间距离处,出现了大约2个镁和大约2个硅相邻阳离子。这种局部结构是锂蒙脱石片层边缘内球单核表面络合物的特征。即使在低离子强度下这些络合物的存在显然与动力学结果相矛盾,因为已知可交换的二价阳离子会形成外球表面络合物。为了阐明这个问题,假设阳离子交换始终处于平衡状态,从溶质钴浓度计算出吸附在交换位点上的钴的量。这些计算表明,吸附的钴在48小时内从交换位点转移到边缘吸附位点。版权所有1999年学术出版社。