Caling B, Lee M
School of Physiotherapy, Faculty of Health Sciences, University of Sydney, Australia.
J Manipulative Physiol Ther. 2001 Feb;24(2):71-8. doi: 10.1067/mmt.2001.112568.
The purpose of this study was to investigate whether changing the direction of applied force affects measured posteroanterior stiffness and associated pelvic (sacral) and lower thoracic rotations.
A repeated measures design was used.
University biomechanical laboratory.
Twenty-four subjects (14 male, 10 female) with no history of recent low back pain or contraindications to mobilization volunteered for testing.
Posteroanterior stiffness was assessed at vertebral levels L3 and L5 through use of 3 sagittal plane directions of applied force; the directions differed by 10 degrees. The amount of sacral and lower thoracic rotation that occurred during loading between 30 and 100 N was also recorded.
A small but significant variation of stiffness with direction of applied force was found. At L3, mean stiffness was greatest when the posteroanterior force was applied in a base direction; it was 11% less when the force was applied 10 degrees more caudad than the base direction and 14% less when the force was applied 10 degrees more cephalad than the base direction. There was no significant effect of direction when the force was applied at L5. Both sacral and thoracic rotations displayed significant variation with direction of force when load was applied at L5, with decreasing rotation as the force was applied in a more caudal direction.
Posteroanterior stiffness in individuals without back pain is affected by the sagittal plane direction in which the posteroanterior force is applied to the lumbar spine. Remote (thoracic and sacral) movements are also affected by the direction of posteroanterior force. Direction of applied force should therefore be controlled, particularly in the research setting.
本研究旨在调查施加力的方向改变是否会影响测量的前后刚度以及相关的骨盆(骶骨)和下胸椎旋转。
采用重复测量设计。
大学的生物力学实验室。
24名无近期腰痛病史或无动员禁忌证的受试者(14名男性,10名女性)自愿参加测试。
通过使用3个矢状面施加力的方向评估L3和L5椎体水平的前后刚度;这些方向相差10度。还记录了在30至100 N加载过程中发生的骶骨和下胸椎旋转量。
发现刚度随施加力的方向存在微小但显著的变化。在L3,当在基底方向施加前后力时,平均刚度最大;当力在比基底方向尾侧多10度的方向施加时,刚度降低11%;当力在比基底方向头侧多10度的方向施加时,刚度降低14%。当在L5施加力时,方向没有显著影响。当在L5施加力时,骶骨和胸椎旋转均随力的方向显示出显著变化,随着力在更尾侧的方向施加,旋转减少。
无背痛个体的前后刚度受腰椎前后力施加矢状面方向的影响。远距离(胸椎和骶骨)运动也受前后力方向的影响。因此,应控制施加力的方向,尤其是在研究环境中。