Rodriguez-Wells V, Plotch S J, DeStefano J J
Department of Cell Biology and Molecular Genetics, University of Maryland College Park, Building 231, College Park, MD 20742, USA.
Nucleic Acids Res. 2001 Jul 1;29(13):2715-24. doi: 10.1093/nar/29.13.2715.
Properties of poliovirus RNA-dependent RNA polymerase (3D(pol)) including optimal conditions for primer extension, processivity and the rate of dissociation from primer-template (k(off)) were examined in the presence and absence of viral protein 3AB. Primer-dependent polymerization was examined on templates of 407 or 1499 nt primed such that fully extended products would be 296 or 1388 nt, respectively. Maximal primer extension was achieved with low rNTP concentrations (50-100 microM) using pH 7 and low (<1 mM) MgCl(2) and KCl (<20 mM) concentrations. However, high activity (about half maximal) was also observed with 500 microM rNTPs providing that higher MgCl(2) levels (3-5 mM) were used. The enhancement observed with the former conditions appeared to result from a large increase in the initial level or active enzyme that associated with the primer. 3AB increased the number of extended primers at all conditions with no apparent change in processivity. The k(off) values for the polymerase bound to primer-template were 0.011 +/- 0.005 and 0.037 +/- 0.006 min(-1) (average of four or more experiments +/- SD) in the presence or absence of 3AB, respectively. The decrease in the presence of 3AB suggested an enhancement of polymerase binding or stability. However, binding was tight even without 3AB, consistent with the highly processive (at least several hundred nucleotides) nature of 3D(pol). The results support a mechanism whereby 3AB enhances the ability of 3D(pol) to form a productive complex with the primer-template. Once formed, this complex is very stable resulting in highly processive synthesis.
在有或无病毒蛋白3AB存在的情况下,研究了脊髓灰质炎病毒RNA依赖性RNA聚合酶(3D(pol))的特性,包括引物延伸的最佳条件、持续合成能力以及从引物-模板解离的速率(k(off))。在407或1499 nt的模板上进行引物依赖性聚合反应,引物设计使得完全延伸的产物分别为296或1388 nt。在pH 7以及低(<1 mM)MgCl₂和KCl(<20 mM)浓度条件下,使用低rNTP浓度(50 - 100 μM)可实现最大引物延伸。然而,若使用500 μM rNTPs并提高MgCl₂水平(3 - 5 mM),也可观察到较高活性(约为最大值的一半)。在前一种条件下观察到的增强作用似乎源于与引物结合的初始活性酶水平大幅增加。在所有条件下,3AB均增加了延伸引物的数量,而持续合成能力无明显变化。在有或无3AB存在的情况下,与引物-模板结合的聚合酶的k(off)值分别为0.011 ± 0.005和0.037 ± 0.006 min⁻¹(四个或更多实验的平均值 ± 标准差)。3AB存在时k(off)值的降低表明聚合酶结合或稳定性增强。然而,即使没有3AB,结合也很紧密,这与3D(pol)的高度持续合成能力(至少几百个核苷酸)相符。这些结果支持了一种机制,即3AB增强了3D(pol)与引物-模板形成有效复合物的能力。一旦形成,这种复合物非常稳定,从而导致高度持续的合成。