Smolewski P, Bedner E, Gorczyca W, Darzynkiewicz Z
Brander Cancer Research Institute, New York Medical College, Valhalla, New York 10532, USA.
Cytometry. 2001 Aug 1;44(4):355-60. doi: 10.1002/1097-0320(20010801)44:4<355::aid-cyto1127>3.0.co;2-w.
Conventional staining of cells or tissue sections on microscope slides involves immersing the slides into solutions of dyes then rinsing to remove the unbound dye. There are instances, however, when use of stain solutions is undesirable-e.g., at microgravity conditions in space, where the possibility of accidental spill (many dyes are known carcinogens) introduces health hazard. Likewise, transporting bulk of liquid stains and rinses may be burdensome in certain situations such as field expeditions or combat.
The "liquidless" staining procedure is proposed in which the dyes are contained in thin strips of hydrated polyacrylamide or gelatin gels that have been presoaked in the stain solutions. Fluorochromes that have affinity to DNA (propidium iodide, PI; 4,6-diamidino-2-phenylindole, DAPI, Hoechst 33342) or to protein (sulforhodamine 101) were used to saturate the gels. The gel strips were placed over the prefixed cells or tissue sections deposited on microscope slides and relatively low (20 g/cm2) pressure was applied to ensure the contact. The cells were also stained by using commercially available mounting media into which DAPI or PI were admixed. Intensity of fluorescence of the PI stained cells was measured by laser scanning cytometry (LSC).
Satisfactory cell and tissue staining, with minimal background, was achieved after 10-20 min contact between the cells and gels. Optimal concentrations of the dyes in the solutions used to presoak the gels was found to be 2-4-fold higher than the concentrations used routinely in cytometry. The measurements of intensity of cellular fluorescence by LSC revealed that the staining of DNA was stoichiometric as reflected by the characteristic cellular DNA content frequency histograms with distinct G1, S, and G2/M cell populations and 2:1 ratio of G2/M to G1 peak fluorescence. Individual gels can be saturated with more than a single dye-e.g., to obtain differential DNA and protein staining. Cell staining with DAPI or PI in the gelatin-based mounting media led to high fluorescence background while staining with DAPI in "aqueous" medium was satisfactory.
Relatively fast staining of cells or tissue sections on microscope slides can be achieved by nonconvective dye diffusion using hydrated gels permeated with the dyes, applied to cells at low pressure. The quality of the staining provided by this methodology is comparable to conventional cell staining in dye solutions.
在显微镜载玻片上对细胞或组织切片进行常规染色时,需将载玻片浸入染料溶液中,然后冲洗以去除未结合的染料。然而,在某些情况下使用染色溶液并不理想,例如在太空微重力条件下,意外溢出的可能性(许多染料是已知的致癌物)会带来健康危害。同样,在某些情况下,如野外考察或战斗中,运输大量的液体染料和冲洗液可能会很麻烦。
提出了“无液”染色程序,其中染料包含在预先浸泡在染色溶液中的水合聚丙烯酰胺或明胶凝胶细条中。使用对DNA有亲和力的荧光染料(碘化丙啶,PI;4,6-二脒基-2-苯基吲哚,DAPI,Hoechst 33342)或对蛋白质有亲和力的荧光染料(磺酰罗丹明101)使凝胶饱和。将凝胶条放置在沉积在显微镜载玻片上的预先固定的细胞或组织切片上,并施加相对较低(20 g/cm²)的压力以确保接触。细胞也通过使用混入DAPI或PI的市售封片剂进行染色。通过激光扫描细胞术(LSC)测量PI染色细胞的荧光强度。
细胞与凝胶接触10 - 20分钟后,实现了令人满意的细胞和组织染色,背景最小。发现用于预先浸泡凝胶的溶液中染料的最佳浓度比细胞计数中常规使用的浓度高2 - 4倍。通过LSC测量细胞荧光强度表明,DNA染色是化学计量的,这由具有明显的G1、S和G2/M细胞群体以及G2/M与G1峰值荧光2:1比例的特征性细胞DNA含量频率直方图反映。单个凝胶可以用不止一种染料饱和,例如,以获得不同的DNA和蛋白质染色。在基于明胶的封片剂中用DAPI或PI对细胞染色会导致高荧光背景,而在“水性”介质中用DAPI染色则令人满意。
通过使用渗透有染料的水合凝胶以非对流方式进行染料扩散,并在低压下应用于细胞,可以在显微镜载玻片上实现细胞或组织切片的相对快速染色。该方法提供的染色质量与在染料溶液中的常规细胞染色相当。