da Cunha Maurício Pereira, Fagundes Saulo de A
Department of Electrical and Computer Engineering, University of Maine, Orono 04469, USA.
IEEE Trans Ultrason Ferroelectr Freq Control. 2002 Jun;49(6):815-9. doi: 10.1109/tuffc.2002.1009341.
New materials of the trigonal 32 class have received much attention recently, due to their quartz-like temperature behavior and the promise of higher electromechanical coupling coefficients. The magnitude and phase of the reflection coefficient of the metal strips that form the SAW transducers and reflector structures is a critical parameter that allows proper device designs and optimal material surface orientation. This paper describes an investigation of the magnitude and phase of the SAW metal strip reflectivity in some new materials and along new orientations. The materials are langanite, langasite, and gallium phosphate. The results are presented as contour plots of the magnitude and phase of the reflection coefficient. In addition, the phase velocity, temperature coefficient of delay, electromechanical coupling coefficient, and power flow angle are given, thus allowing proper orientation selection for SAW device designs. The results presented highlight the reflection coefficient calculations in the selection of natural single-phase unidirectional transducer orientations (NSPUDT) for these new materials. As a result of the present work, reflection coefficient magnitudes five times larger than those of the well-known quartz NSPUDT orientation (Euler angles: 0 degrees 132.75 degrees 25 degrees) can be obtained with the new materials, for orientations where the optimum NSPUDT reflection coefficient phase criterion is met. The new materials discussed here provide an opportunity to design shorter- and higher-bandwidth devices due to: the increased electromechanical coupling coefficient; the higher reflection coefficient; and the lower phase velocities; while maintaining the excellent temperature insensitivity characteristic of quartz. The orientation regions suggested in this paper for the new materials are thus very promising for low-loss, high-performance consumer and communications SAW designs, such as NSPUDT filters, resonator-based filters, and other devices that can benefit from a high metal strip reflectivity.
