Retentive properties of five different luting cements on base and noble metal copings.

STATEMENT OF PROBLEM

The retention of indirectly fabricated restorations can be compromised by short or over-tapered tooth preparations.

PURPOSE

The aim of this study was to evaluate the retentive properties of 5 different luting cements on base and noble metal copings to short and over-tapered preparations.

MATERIAL AND METHODS

Eighty extracted mandibular premolars were prepared to receive full cast copings with a flat occlusal surface, 33 degrees taper, and 3-mm axial length. Half of the standardized metal copings were cast in an AuAgPd alloy, whereas the other half were cast in an NiCr alloy. Cementation was performed with 5 different luting cements through use of 5 kg of pressure in 90% relative humidity. Specimens were stored in distilled water at 37 degrees C for 24 hours and thermocycled between 5 degrees C and 55 degrees C for 5000 cycles, with a dwell time of 30 seconds. After thermocycling, vertical tensile force was applied in a Zwick universal testing machine with a constant speed of 1 mm/min until separation was noted. A 2-factor analysis of variance was used to analyze the data, with a significance level of alpha =.05.

RESULTS

Mean dislodgement forces for AuAgPd crowns and NiCr crowns were 120.88 N and 143.09 N, respectively, for zinc phosphate cement; 135.45 N and 150.38 N for Principle; 145.88 N and 220.71 N for Meron; 276.85 N and 225.61 N for Avanto; and 300.92 N and 381.02 N for Fuji Plus.

CONCLUSION

Within the limitations of this study, Fuji Plus and Avanto showed significantly higher retentive strengths for AuAgPd copings in comparison to the other cements tested (P <.05). The retentive strength of Fuji Plus was significantly higher than those of the other cements tested with NiCr copings (P <.05).