Thomas N E, Coakley W T, Akay G
School of Pure and Applied Biology, University of Wales College, Cardiff, UK.
Cell Biophys. 1992 Apr-Jun;20(2-3):125-47. doi: 10.1007/BF02823654.
The form of contact seam (whether a continuous parallel seam or membranes in spatially periodic contact) has been characterized for normal and for neuraminidase pretreated human erythrocytes following adhesion in solutions of polylysine in the molecular mass range 10-225 kDa at concentrations from 0.5 to 1.0 mg/mL. The adhesion contact seam was spatially periodic for all normal control cells in polylysine. The lateral separation of contacts decreased from 1.6 to 0.8 microns as the concentration of 225 kDa polylysine was increased threefold from the adhesion threshold value. The separation distance did not change further even at high polymer concentrations that increased the electrophoretic velocity to positive values over twice the modulus of the velocity of control cells. The probability of cell adhesion decreased at these high polymer concentrations. The lateral contact separation increased and cell adhesion decreased for cells pretreated with neuraminidase. Cell adhesion did not occur when neuraminidase reduced the cell electrophoretic velocity modulus by 30%. Following neuraminidase pretreatments that allowed a small amount of adhesion, the cell contact seam was continuous rather than spatially periodic. The results show that a procedure that increases (e.g., polymer concentration increase) or decreases (e.g., enzyme removal of polycation crosslinking site) attraction leads to shorter (to a limiting value) or longer lateral contact separation, respectively.
在分子量范围为10 - 225 kDa、浓度为0.5至1.0 mg/mL的聚赖氨酸溶液中,正常的和经神经氨酸酶预处理的人红细胞在粘附后,已对接触缝的形式(无论是连续平行缝还是空间周期性接触的膜)进行了表征。对于聚赖氨酸中的所有正常对照细胞,粘附接触缝是空间周期性的。随着225 kDa聚赖氨酸的浓度从粘附阈值增加三倍,接触的横向间距从1.6微米减小到0.8微米。即使在高聚合物浓度下,分离距离也不再变化,此时电泳速度增加到正值,超过对照细胞速度模量的两倍。在这些高聚合物浓度下,细胞粘附的概率降低。对于经神经氨酸酶预处理的细胞,横向接触间距增加且细胞粘附减少。当神经氨酸酶使细胞电泳速度模量降低30%时,细胞不发生粘附。在允许少量粘附的神经氨酸酶预处理后,细胞接触缝是连续的而非空间周期性的。结果表明,增加(例如,增加聚合物浓度)或减少(例如,酶去除聚阳离子交联位点)吸引力的过程分别导致横向接触间距更短(至极限值)或更长。