Meyer U, Pöpel H J
Vivendi Water Germany, Walter-Köhn-Str. 1a, 04356 Leipzig, Germany.
Water Sci Technol. 2003;47(11):69-76.
In the last few years, numerous studies were carried out, dealing with the application of fuzzy-logic to improve the control of the activated sludge process. In this paper, fuzzy-logic based control strategies for wastewater treatment plants with pre-denitrification are presented that should lead to better effluent quality and, in parallel, to a reduction of energy consumption. Extensive experimental investigations on a large scale pilot plant as well as simulation studies (ASM1 with SIMBA) were carried out in order to design, evaluate and compare different fuzzy-controllers with each other and with comparable conventional control systems. The fuzzy-controllers were designed as high-level controllers that determine the DO-setpoints in the aerated zones and the ratio between aerated and non-aerated zones. Conventional PI-controllers were used to maintain the DO-concentration at the set-point levels. The ammonia and nitrate concentration in the effluent and the ammonia load in the influent were considered as input variables for the different fuzzy-controllers. Compared to the operation with fixed nitrification/denitrification zones and constant DO concentrations, the required air-flow could be reduced up to 24% by using fuzzy-logic based control strategies. In comparison with a more advanced conventional control strategy (relay controller with two thresholds and the NH4-N concentration in the effluent as single control variable) a reduction of air-flow-rate up to 14% could be achieved. At the same time, NH4-N peaks in the effluent that are normally caused by peak flow conditions could be reduced significantly. The large scale experiments show that the fuzzy-controllers can be easily implemented in modern control and supervision systems and that the control characteristics can be followed and modified during operation. It therefore can be expected that the developed fuzzy-control systems will be accepted by the operating personnel in wastewater treatment plants.
在过去几年中,开展了大量研究,涉及应用模糊逻辑来改善活性污泥法的控制。本文提出了基于模糊逻辑的前置反硝化污水处理厂控制策略,该策略应能带来更好的出水水质,同时降低能耗。为了设计、评估和比较不同的模糊控制器以及与类似的传统控制系统,在大型中试装置上进行了广泛的实验研究,并开展了模拟研究(使用SIMBA的ASM1)。模糊控制器被设计为高级控制器,用于确定曝气区的溶解氧设定点以及曝气区与非曝气区的比例。使用传统的PI控制器将溶解氧浓度维持在设定水平。出水氨氮和硝酸盐浓度以及进水氨负荷被视为不同模糊控制器的输入变量。与固定硝化/反硝化区和恒定溶解氧浓度的运行方式相比,采用基于模糊逻辑的控制策略可将所需空气流量降低多达24%。与更先进的传统控制策略(具有两个阈值的继电器控制器,以出水氨氮浓度作为单一控制变量)相比,可将空气流量降低多达14%。同时,通常由流量峰值条件导致的出水氨氮峰值可显著降低。大规模实验表明,模糊控制器可轻松应用于现代控制和监控系统,并且控制特性在运行期间可被跟踪和修改。因此,可以预期所开发的模糊控制系统将被污水处理厂的操作人员所接受。