Boylan Douglas, Greis Patrick E, West John R, Bachus Kent N, Burks Robert T
Doylestown Orthopedic Specialists, Doylestown, Pennsylvania, USA.
Arthroscopy. 2003 Sep;19(7):700-5. doi: 10.1016/s0749-8063(03)00400-6.
Tension degradation within hamstring grafts and anterior knee laxity were analyzed in a cadaveric anterior cruciate ligament (ACL) reconstruction model undergoing cyclic motion. It was hypothesized that suture fixation of a hamstring graft would lose tension during cycling initially and then stabilize, and that anterior knee laxity would increase as tension was lost. Hamstring grafts fixed under 3 different loads were evaluated to determine how initial graft tension affected knee laxity after cyclic motion.
Cadaveric biomechanical analysis.
Eighteen pairs of fresh-frozen hamstring tendons were tested on 2 cadaveric knees undergoing ACL reconstruction. The hamstring pairs were separated equally and randomly into one of 3 tension groups: 68 N (15 lb), 45 N (10 lb), and 23 N (5 lb). The loads were applied to the graft at 30 degrees of flexion, and the grafts were secured to the tibia with a suture and post technique. The knee was then cycled 1,000 times using an Instron machine (Instron, Canton, MA) through a range of motion between 0 degrees to 90 degrees. Constant monitoring and recording of graft tension was performed. A KT-1000 (Medmetrics, San Diego, CA) was performed (1) on the intact knee, (2) after ACL excision, (3) after ACL reconstruction and initial graft fixation, and (4) at the completion of the 1,000 cycles. An analysis of variance test was used to evaluate data.
The tension within the grafts after 1,000 cycles decreased to 34.5 N (7.6 lb), 16.8 N (3.7 lb), and 15.4 N (3.4 lb) from the preloads of 68, 45, and 23 N, respectively (P <.05 in all cases). This represented an average decrease of 50.2% of the initial tension after 1,000 cycles. Manual-maximum KT testing of the intact knees was 5.8 +/- 0.3 mm, and after ACL excision was 13.2 +/- 0.9 mm. KT testing revealed 6.0 +/- 0.9 mm, 8.1 +/- 1.9 mm, and 8.9 +/- 1.1 mm of anterior translation after fixation in the tension groups of 68, 45, and 23 N, respectively. After 1,000 cycles, the translation increased to 7.8 +/- 1.0 mm, 10.5 +/- 1.9 mm, and 10.3 +/- 1.5 mm, respectively.
This study showed that initial graft tension decreases with cyclic loading, resulting in increased knee laxity. To restore anterior translation to within 3 mm of the native ACL condition after cyclic loading, approximately 68 N of initial tension is required using this fixation technique.
在一个进行循环运动的尸体前交叉韧带(ACL)重建模型中,分析腘绳肌移植物内的张力降解情况以及膝关节前部松弛度。研究假设为,腘绳肌移植物的缝线固定在循环运动开始时会失去张力,随后趋于稳定,并且随着张力的丧失,膝关节前部松弛度会增加。对在3种不同负荷下固定的腘绳肌移植物进行评估,以确定初始移植物张力如何影响循环运动后膝关节的松弛度。
尸体生物力学分析。
在2具接受ACL重建的尸体膝关节上测试18对新鲜冷冻的腘绳肌腱。将腘绳肌对平均且随机地分为3个张力组之一:68 N(15磅)、45 N(10磅)和23 N(5磅)。在膝关节屈曲30度时对移植物施加负荷,并采用缝线和桩技术将移植物固定于胫骨。然后使用英斯特朗机器(英斯特朗公司,马萨诸塞州坎顿)使膝关节在0度至90度的运动范围内循环运动1000次。对移植物张力进行持续监测和记录。使用KT - 1000(Medmetrics公司,加利福尼亚州圣地亚哥)在以下情况下进行测试:(1)完整膝关节;(2)ACL切除后;(3)ACL重建及初始移植物固定后;(4)1000次循环结束时。采用方差分析测试来评估数据。
1000次循环后,移植物内的张力分别从预负荷68 N、45 N和23 N降至34.5 N(7.6磅)、16.8 N(3.7磅)和15.4 N(3.4磅)(所有情况下P <.05)。这表明1000次循环后初始张力平均下降了50.2%。完整膝关节的手动最大KT测试值为5.8±0.3 mm,ACL切除后为13.2±0.9 mm。KT测试显示,在68 N、45 N和23 N张力组中,固定后膝关节前部平移分别为6.0±0.9 mm、8.1±1.9 mm和8.9±1.1 mm。1000次循环后,平移分别增加至7.8±1.0 mm、10.5±1.9 mm和10.3±1.5 mm。
本研究表明,初始移植物张力随循环负荷而降低,导致膝关节松弛度增加。使用该固定技术,为使循环负荷后膝关节前部平移恢复至天然ACL状态下3 mm以内,初始张力大约需要68 N。