Suppr超能文献

中空纤维生物人工肝中的氧消耗——再探讨。

Oxygen consumption in a hollow fiber bioartificial liver--revisited.

作者信息

Patzer John F

机构信息

Department of Surgery, Department of Chemical Engineering, Thomas E Starzl Transplantation Institute, McGowan Institute for Regenerative Medicine, University of Pittsburgh, Pittsburgh, PA 15261, USA.

出版信息

Artif Organs. 2004 Jan;28(1):83-98. doi: 10.1111/j.1525-1594.2004.07150.x.

Abstract

Oxygen consumption dynamics in a hollow fiber, hepatocyte-loaded bioartificial liver are investigated both theoretically and experimentally. The theoretical model is based upon the Krogh cylinder, which approximates the bioreactor as a collection of cylindrical elements comprised of an inner fiber lumen for media perfusion, the fiber wall through which oxygen can diffuse, and an annular region of hepatocytes surrounding the fiber. The primary non-dimensional parameters that describe the system are: (i) the Peclet number, Pe, which is the ratio of convective oxygen transport through the lumen to diffusive oxygen transport to the fiber walls; (ii) the hepatocyte saturation parameter, theta, which is the ratio of the inlet oxygen partial pressure to the Michaelis-Menten half-rate oxygen partial pressure; (iii) the Thiele modulus, phi2, which is the ratio of oxygen consumption rate to oxygen diffusion rate in the hepatocyte annulus; (iv) the hepatocyte permeability ratio, beta31, which is the ratio of oxygen permeability in the hepatocyte cell mass to oxygen permeability in the perfusing lumen medium; and (v) the hepatocyte annular thickness, rho3, which is the ratio of the exterior hepatocyte annular radius to the fiber lumen radius. Only Pe and theta are easily manipulated operating variables. phi2, beta31, and rho3 are engineering design parameters that are set when a bioreactor is fabricated. The model results are expressed as the effective hepatocyte utilization ratio, Vratio, which is the ratio of the observed oxygen consumption rate to the intrinsic hepatocyte oxygen consumption rate. Large regions of Vratio > 0.9, which is deemed an acceptable effective hepatocyte utilization are found for parameter values consistent with standard hollow fiber cartridges used in bioartificial liver fabrication. The extent of the Vratio > 0.9 region increases to a plateau with increasing Pe, increases with increasing theta, decreases with increasing phi2, increases with increasing beta31, and decreases with increasing rho3. The theoretical results indicate that Vratio > 0.9 is found whenever the experimentally observed fractional oxygen consumption from the perfusing medium, is less than 0.25. Combination of the theoretical and experimental results indicate that intrinsic, per cell oxygen consumption in the hollow fiber system may decrease as hepatocyte cell density increases and that this decrease may be due to lower intrinsic oxygen requirements in denser suspensions and not due to diffusion limitations in oxygen transport in the hollow fiber system as might be expected from two-dimensional, monolayer culture oxygen consumption measurements.

摘要

对中空纤维负载肝细胞的生物人工肝中的氧气消耗动力学进行了理论和实验研究。理论模型基于克罗格圆柱体,该模型将生物反应器近似为一组圆柱形元件,包括用于培养基灌注的内部纤维腔、氧气可透过的纤维壁以及围绕纤维的肝细胞环形区域。描述该系统的主要无量纲参数为:(i) 佩克莱数Pe,它是通过腔的对流氧气传输与向纤维壁的扩散氧气传输的比率;(ii) 肝细胞饱和参数theta,它是入口氧气分压与米氏半速率氧气分压的比率;(iii) 蒂勒模数phi2,它是肝细胞环中的氧气消耗速率与氧气扩散速率的比率;(iv) 肝细胞渗透率比beta31,它是肝细胞团中的氧气渗透率与灌注腔培养基中的氧气渗透率的比率;以及(v) 肝细胞环形厚度rho3,它是外部肝细胞环形半径与纤维腔半径的比率。只有Pe和theta是易于控制的操作变量。phi2、beta31和rho3是生物反应器制造时设定的工程设计参数。模型结果表示为有效肝细胞利用率Vratio,它是观察到的氧气消耗速率与固有肝细胞氧气消耗速率的比率。对于与生物人工肝制造中使用的标准中空纤维盒一致的参数值,发现了Vratio > 0.9的大区域,这被认为是可接受的有效肝细胞利用率。Vratio > 0.9区域的范围随着Pe的增加而增加到一个平稳状态,随着theta的增加而增加,随着phi2的增加而减少,随着beta31的增加而增加,随着rho3的增加而减少。理论结果表明,只要从灌注培养基中实验观察到的氧气消耗分数小于0.25,就会发现Vratio > 0.9。理论和实验结果的结合表明,中空纤维系统中固有细胞的氧气消耗可能会随着肝细胞密度的增加而降低,并且这种降低可能是由于较密集悬浮液中较低的固有氧气需求,而不是如二维单层培养氧气消耗测量所预期的那样,是由于中空纤维系统中氧气传输存在扩散限制。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验