Suppr超能文献

卡波姆和诺维隆压块的玻璃化转变及粘弹性特性

Glass transitions and viscoelastic properties of carbopol and noveon compacts.

作者信息

Gómez-Carracedo A, Alvarez-Lorenzo C, Gómez-Amoza J L, Concheiro A

机构信息

Departamento de Farmacia y Tecnología Farmacéutica, Facultad de Farmacia, Universidad de Santiago de Compostela, 15782 Santiago de Compostela, Spain.

出版信息

Int J Pharm. 2004 Apr 15;274(1-2):233-43. doi: 10.1016/j.ijpharm.2004.01.023.

Abstract

Glass transitions of five varieties of Carbopol (acrylic acid polymers cross-linked with allyl sucrose or allyl pentaerythritol) and two varieties of Noveon (calcium salts of acrylic acid polymer cross-linked with divinylglycol) differing in cross-linking density and nature and content in residual solvents, were analysed (as compressed probes) by differential scanning calorimetry (DSC), modulated temperature differential scanning calorimetry (MTDSC), and oscillatory rheometry. All carbopol compacts showed a main glass transition, at a temperature between 130 and 140 degrees C, Tg, independently of their cross-linking degree and molecular weight. Additionally two batches of Carbopol 971P, which had greater contents in residual solvents, also presented a secondary transition at 65-70 degrees C. Sorption of water during storage of carbopol compacts at different relative humidity environments caused the Tg to strongly decrease. Compacts stored at 97.5% relative humidity have Tg below 0 degrees C and behave, at room temperature, as flexible hydrogels. The Gordon-Taylor/Kelley-Bueche equation only fit the dependence of Tg on water content well for carbopol compacts containing less than 15% water. The plasticizing effect of water was clearly evidenced in the considerable decrease in the storage and loss moduli of the compacts. Although the energy associated to the glass transitions of carbopol polymers, 0.40-0.50 Jg(-1) degrees C(-1), is high enough to be clearly detected by DSC, in some cases the evaporation of residual solvents may make it difficult to observe the Tg. This inconvenience is overcome using MTDSC or oscillatory rheometry. The decrease in Tg of carbopol caused by water sorption when compacts were stored at 97.5% R.H. explains why their loss (G") and storage (G') moduli at room temperature decreased four orders of magnitude. In contrast, in noveon varieties, calcium ions act as ionic cross-linkers of the carboxylic groups, providing rigid networks with much higher Tg, and storage and loss moduli. This explains that despite sorbing similar amounts of water to carbopol, the changes on the mechanical properties of noveon compacts were much less important (i.e., G' and G" decreased up to one order of magnitude).

摘要

分析了交联密度、性质以及残留溶剂含量不同的五种卡波姆(与烯丙基蔗糖或烯丙基季戊四醇交联的丙烯酸聚合物)和两种诺誉产品(与二乙烯二醇交联的丙烯酸聚合物钙盐)的玻璃化转变(作为压缩探针),采用差示扫描量热法(DSC)、调制温度差示扫描量热法(MTDSC)和振荡流变学方法。所有卡波姆压片均显示出一个主要的玻璃化转变,温度在130至140摄氏度之间,即Tg,与它们的交联度和分子量无关。此外,两批残留溶剂含量较高的卡波姆971P在65 - 70摄氏度时还出现了二次转变。卡波姆压片在不同相对湿度环境下储存时对水的吸附导致Tg大幅降低。在97.5%相对湿度下储存的压片其Tg低于0摄氏度,在室温下表现为柔性水凝胶。对于含水量小于15%的卡波姆压片,Gordon - Taylor/Kelley - Bueche方程仅能很好地拟合Tg对含水量的依赖性。水的增塑作用在压片储能模量和损耗模量的显著降低中得到了明显证明。尽管与卡波姆聚合物玻璃化转变相关的能量为0.40 - 0.50 Jg⁻¹℃⁻¹,高到足以通过DSC清晰检测,但在某些情况下,残留溶剂的蒸发可能会使观察Tg变得困难。使用MTDSC或振荡流变学可以克服这一不便。当压片在97.5%相对湿度下储存时,水吸附导致卡波姆的Tg降低,这解释了为什么它们在室温下的损耗(G")和储能(G')模量降低了四个数量级。相比之下,在诺誉产品中,钙离子作为羧基的离子交联剂,提供了具有更高Tg以及储能和损耗模量的刚性网络。这解释了尽管诺誉产品吸附的水量与卡波姆相似,但其压片力学性能的变化却小得多(即G'和G"降低了一个数量级)。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验